Author |
Message |
Bernd_f
| Posted on Saturday, July 25, 2015 - 06:44 am: |
|
Hello I am since three days happy owner of a Buell 1125 CR 2010 and I love it. But currently I have following behavior: The bike governs at 8500 RPM so I am not able to use the full power of the bike. Does someone have any idea? If it helps I have also an complete exan exhaust system which still was on the bike. Thanks in Advance! Best Regards, Bernd |
Two_seasons
| Posted on Saturday, July 25, 2015 - 08:25 am: |
|
You did not say what gear the bike was in when you hit an 8500 rpm limit. Have you de-noided? |
Bernd_f
| Posted on Saturday, July 25, 2015 - 09:51 am: |
|
in the first, second and third gear I know it but it the others I don't know. I don't know what de-noided is. Where I can have a look for that? |
Bernd_f
| Posted on Saturday, July 25, 2015 - 10:07 am: |
|
At 8500 it is like a down regulation and I am not able also if I a atay on gas that I become more accelaration. |
Nikoff90
| Posted on Saturday, July 25, 2015 - 11:44 am: |
|
Does Austria have a HP limit for motorcycles? |
Bernd_f
| Posted on Saturday, July 25, 2015 - 11:47 am: |
|
I don't think so because but next week I will talm with the old bile owner. |
Dannybuell
| Posted on Saturday, July 25, 2015 - 11:28 pm: |
|
look for oil breather line interfering with throttle linkage, it slips down sometimes. |
Shawns
| Posted on Sunday, July 26, 2015 - 07:39 am: |
|
One of my upper throttle body clamps was interfering with my linkage. Food for thought. |
Zac4mac
| Posted on Sunday, July 26, 2015 - 03:03 pm: |
|
AFAIK, only the French version was limited in HP. Best bet is the breather hose interfering. Remove outer and inner airboxes, find the breather mid-right side. It should be sticking out of the base by 1/2-3/4 inches, 12-19mm. Don't pull too hard, it's other end is hard to get to. Zack <edit> Go into Diagnostic Mode by pressing Mode and Select while turning key to ON or Park. Cycle thru sensor values until you reach TPS percent, you should see 2-100%. (Message edited by zac4mac on July 26, 2015) |
Bernd_f
| Posted on Tuesday, July 28, 2015 - 07:03 am: |
|
Thanks a lot for the Information. I will give Feedback end of the week what are my results! |
Xtreme6669
| Posted on Tuesday, July 28, 2015 - 11:28 am: |
|
When your looking at your tips data in the cluster in Diag mode you need to make sure that you have the on/off rocker switch flipped to on. You will not get the full 2 - 100% swing if the switch is In The off position. |