G oog le BadWeB | Login/out | Topics | Search | Custodians | Register | Edit Profile

Buell Forum » Quick Board Archives » Archive through September 14, 2007 » 2006 uly no start...push button and nothing at all. HELP « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Andrejs2112
Posted on Tuesday, September 11, 2007 - 04:24 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

Leaving work. Turn key, kill switch on, dash lights, efi makes noise, push starter, NOTHING! no noise at all just nothing. What's the problem?
Top of pagePrevious messageNext messageBottom of page Link to this message

Hootowl
Posted on Tuesday, September 11, 2007 - 04:28 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

Is it in gear? Check your fuses?
Top of pagePrevious messageNext messageBottom of page Link to this message

Andrejs2112
Posted on Tuesday, September 11, 2007 - 04:36 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

Not in gear, fuses good, 12.72 volts, terminals tight and clean, no dimming or anything when pushing button.
Top of pagePrevious messageNext messageBottom of page Link to this message

Andrejs2112
Posted on Tuesday, September 11, 2007 - 04:39 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

just started. dicked with the shifter in and out of gear and back to n . started up. WTF? it starts in or out of gear and you don't need the clutch pulled in to start. Strange. I no likey this. To be continued...

THanks for the reply.
Top of pagePrevious messageNext messageBottom of page Link to this message

Barker
Posted on Tuesday, September 11, 2007 - 04:43 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

neutral sensor gone wacky?
Top of pagePrevious messageNext messageBottom of page Link to this message

Torquemonster
Posted on Tuesday, September 11, 2007 - 05:08 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

Dont stop on the way home, and pray you dont stall at a light!
Good luck and ride safe!
Top of pagePrevious messageNext messageBottom of page Link to this message

Andrejs2112
Posted on Tuesday, September 11, 2007 - 07:34 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

My bike will start in any gear position w/o the clutch pulled in. Gear shouldn't, and hasn't made a difference. Anymore ideas?
Top of pagePrevious messageNext messageBottom of page Link to this message

Hexangler
Posted on Tuesday, September 11, 2007 - 07:56 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

Intermittent short in ignition switch or starter button or wiring to or from them?

I've had to replace one (ignition switch) on my Sportster, and one on my Moto Guzzi V50III. Just dead, with no sound.

Hex
Top of pagePrevious messageNext messageBottom of page Link to this message

Johnnylunchbox
Posted on Tuesday, September 11, 2007 - 07:59 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

Bank Angle Sensor recall done?
Top of pagePrevious messageNext messageBottom of page Link to this message

Twintour
Posted on Tuesday, September 11, 2007 - 08:04 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

It's going to happen again, the yellow starter switch on the handle bar contol is dirty.Slip the control housing ,you can service all the switch part. sand off the brass contacts,wire eyelet, mount screw and spring. coat parts with alittle lithium grease.
Top of pagePrevious messageNext messageBottom of page Link to this message

Andrejs2112
Posted on Tuesday, September 11, 2007 - 08:21 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

Bank Angle Sensor recall done?


The dealer said it was, but I can't see it where it should be in the tail. I need to verify.
Top of pagePrevious messageNext messageBottom of page Link to this message

Andrejs2112
Posted on Tuesday, September 11, 2007 - 08:22 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

It's going to happen again, the yellow starter switch on the handle bar contol is dirty.Slip the control housing ,you can service all the switch part. sand off the brass contacts,wire eyelet, mount screw and spring. coat parts with alittle lithium grease.


I take it this happened to you?
Top of pagePrevious messageNext messageBottom of page Link to this message

Twintour
Posted on Tuesday, September 11, 2007 - 08:54 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

Yes, on the way to deals gap . 250miles in, on a 550mile day. If you ride in the rain more often or wash your bike a lot. all the bar controls will become intermittent. They are not high quality control .Which is good because the start switch is a simple spring contact switch. I spray wd-40 in and around my control after washes.
Top of pagePrevious messageNext messageBottom of page Link to this message

Andrejs2112
Posted on Tuesday, September 11, 2007 - 09:02 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

Thanks. I ride in the rain and wash the bike a lot. I'll give it a try.
Top of pagePrevious messageNext messageBottom of page Link to this message

Soloyosh
Posted on Friday, September 14, 2007 - 05:43 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

If it starts in gear without the clutch pulled in you may want to check the clutch switch.

Mine refuses to start with the bars turned to the left. Currently at the dealer. They replaced the clutch switch because it was not functioning, but the starting problem still exists. I'm thinking wiring harness on mine.

Cheers
Brett
« Previous Next »

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a private posting area. Only registered users and custodians may post messages here.
Password:
Options: Post as "Anonymous" (Valid reason required. Abusers will be exposed. If unsure, ask.)
Enable HTML code in message
Automatically activate URLs in message
Action:

Topics | Last Day | Tree View | Search | User List | Help/Instructions | Rules | Program Credits Administration