Author |
Message |
Russmannnn
| Posted on Saturday, July 21, 2012 - 11:25 pm: |
|
I finally get to put my rt3 and EBR ECM back on tomarow, but lost the instruction sheet. Dose anyone have a picture of the process or know what to do? I know there are things to do with the key and throttle as well as letting the bike run for 10 mins. Just cant remember the exact process. Thanks a lot for the help. Russell. |
Bartone
| Posted on Sunday, July 22, 2012 - 01:29 am: |
|
plug in, do tps reset, run bike for 10 mins. |
Russmannnn
| Posted on Sunday, July 22, 2012 - 03:06 am: |
|
I don't remember the steps for the tps reset |
D_adams
| Posted on Sunday, July 22, 2012 - 06:50 am: |
|
Key on, kill switch on, open/close throttle fully 3x in 3-5 seconds, key off, as I recall. Don't let it snap back to closed on it's own, should be a smooth movement in both directions. (Message edited by d_adams on July 22, 2012) |
Froggy
| Posted on Sunday, July 22, 2012 - 12:05 pm: |
|
Sounds like you just took the ecm off, if you didn't install it on another bike then you don't need to reset anything, just plug it in and go. |
Dannybuell
| Posted on Sunday, July 22, 2012 - 12:14 pm: |
|
There is a folder at the bottom of the first screen titled: 'New 1125R/CR Owner Information'. At the next screen there is a thread titled: 'TPS reset procedure ' |
Russmannnn
| Posted on Sunday, July 22, 2012 - 07:28 pm: |
|
Ya I had to replace the engine under warranty and took the pipe and chip out before it went to the dealer. So all I need to do then is un hook the battery and plug in the new one? Sounds easy enough. |
Torquehd
| Posted on Sunday, July 22, 2012 - 09:25 pm: |
|
|
|