| Author | Message | ||
     Mcelhaney14 |
Parts from an 04 or 05 XB12S. I didn't have the whole bike so I don't much on the stuff. I was told that the bike had around 15K miles on it. Will describe to the best of my abilities. All prices + shipping Thanks Heads, rough. Rear lost the piston and the exhaust studs have been broken and drilled way oversize. $200 for the set OBO     (Message edited by mcelhaney14 on February 01, 2014) | ||
| Mcelhaney14 |
Rocker box covers. Look nice with one small rub area. $40    | ||
| Mcelhaney14 |
Primary Cover, has a small dent. $75     | ||
| Mcelhaney14 |
Main wiring Harness. I don't see any cut wires or missing connectors. Part # Y0200.1AA Rev E. Since I don't know anything about it $25    | ||
| Mcelhaney14 |
Oil Lines. Look good. Need cleaning. $20  Exhaust Valve actuators $5 each  Exhaust Clamps and Brackets $10  | ||
| Mcelhaney14 |
Misc Airbox parts, rubber stuff looks good but some parts have been modified. $20  Ignition Coil $15  Belt Idler pulley, sounds like it could use bearings $10  | ||
| Fishxb12 |
Sent u a message on the heads. | ||
| Phelan |
Any chance you have the engine sprocket and primary chain? | ||
| Reepicheep |
I'll take both exhaust actuators. PM me a paypal address and shipping amount. | ||
| Tacpbuell |
I'll take the exhaust clamps.. Pm me Paypal address | ||
| Mcelhaney14 |
Responses sent to all! Will be posting more soon. | ||
| Lynrd |
Rocker boxes please. | ||
| Mcelhaney14 |
Exhaust actuators SOLD Should be in the mail tomorrow. Thanks Bill | ||
| Mcelhaney14 |
Exhaust Clamps Sold Rocker Box Covers Sold | ||
| Mcelhaney14 |
More items Belt guard $10  Chin fairing. One side is broken and its been painted $5   | ||
| Mcelhaney14 |
XB12 crank. Crank pin is shot and rear rod is bent. Also, the snout that goes into the cam cover is scored. May be fixable. $20    | ||
| Mcelhaney14 |
Kick stand mound $5  Push rods and covers $20   | ||
| Mcelhaney14 |
XB SX hand guards $40  Throttle Body with injectors and TPS. Throttle shaft looks good. $50  Owners Manual 05 Firebolt $20  | ||
| Mcelhaney14 |
Cam cover. Cam bushings are good but the crank bushing is scored. Comes with CPS and timing cup. $25   Front engine mount $5  | ||
| Mcelhaney14 |
Rear engine mount. Rubber looks good. $15  27T drive pulley with nut and locking ring $35   | ||
| Mcelhaney14 |
Voltage Regulator, condition unknown but engine blew so it's probably fine. $30   Speed Sensor. Wires are chaffed by the plug again working condition unknown but from the same blown engine. $10   | ||
| Twintalon |
Belt Idler Pulley to 30084? | ||
| Nillaice |
Interested in the primary cover | ||
| Mcelhaney14 |
Idler Pulley Sold and Shipped Primary still available. Never got a message Nillaice | ||
| Phelan |
Interested in these- speed sensor voltage regulator cam cover throttlebody with injectors and tps igniton coil main harness | ||
| Phelan |
PM sent, let me know f you don't get it. (Message edited by phelan on March 01, 2014) | ||
| Zac4mac |
Are the heads still on the block? Z | ||
| Mcelhaney14 |
Heads are still for sale. I will give prior warning, the exhaust stud holes are very nasty on these. | ||
| Skinstains |
Dibs on the pushrods and covers if they are still available... (Message edited by skinstains on March 05, 2014) | ||
| Skinstains |
Is the cam cover and harness still available ? |
