G oog le BadWeB | Login/out | Topics | Search | Custodians | Register | Edit Profile

Buell Forum » Old School Buell » Archives OSB 001 » Archive through July 05, 2005 » Left side axle adjuster « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Twowheeldream
Posted on Monday, June 27, 2005 - 01:59 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

ok, got my bike back from a rear tire and rotor change a couple of weeks ago and a few days later I noticed a funny ringing sound coming from the bike..... took about another week to figure out what it was. you guessed it, the left side axle adjuster was just loose enough that it was rattleing around at idle. So I grab my tools and loosen everything up and start over.... realign the rear wheel, set belt tension (or lack of), and re-tourque.

ride for a day, and axle adjuster is rattling away again.

anyone have any suggestions?
Top of pagePrevious messageNext messageBottom of page Link to this message

Natexlh1000
Posted on Monday, June 27, 2005 - 06:14 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Yes.
The swingarm isn't threaded.
Adjust the axle to where you want it and tighten the axle so it's not going anywhere.
Now apply a slight amount of force to the adjusters and lock the lock nuts.
I think you need two 1/2" wrenches and one 7/16".
Top of pagePrevious messageNext messageBottom of page Link to this message

Denfromphilly
Posted on Monday, June 27, 2005 - 04:31 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

That's two 1/2 in wrenches and a 3/8's.
Top of pagePrevious messageNext messageBottom of page Link to this message

Twowheeldream
Posted on Tuesday, June 28, 2005 - 10:30 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

There is no locknut... its a nylock nut and its a 3/8"

I took a closer look at it today and found out that the "bolt" or threaded rod has actually come loose from the ring that the axle goes through.


Do I hit it with some thread locker and run it back in, or is that not going to be enough to hold it.

(Message edited by twowheeldream on June 28, 2005)

(Message edited by twowheeldream on June 29, 2005)
Top of pagePrevious messageNext messageBottom of page Link to this message

Natexlh1000
Posted on Wednesday, June 29, 2005 - 05:34 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Oh man! I'm sorry. You have the older steel swingarm. I gave you bad advice.
« Previous Next »

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a private posting area. Only registered users and custodians may post messages here.
Password:
Options: Post as "Anonymous" (Valid reason required. Abusers will be exposed. If unsure, ask.)
Enable HTML code in message
Automatically activate URLs in message
Action:

Topics | Last Day | Tree View | Search | User List | Help/Instructions | Rules | Program Credits Administration