Author |
Message |
Servinghimdaily
| Posted on Monday, September 16, 2013 - 11:09 pm: |
|
Recently purchased a 2000 m2. Absolutely love it. Always wanted one, now I do. Here's the issue I'm facing, and could use some direction. I have zero turn signals. Here is what I've done so far. With a volt meter checked following... Fuse (11.75v), flasher relay(@11.75v)' switch(11.75v) into switch on the blue wire...nothing out to any of the 4 turn signals. (Have two switches and both do the same thing. Everything in both switches works except turn signals) The bike does have aftermarket signals(non led). The front left turn signal (black/white wire) has broke away from casing. Don't know if this is the cause or something else? Other than that I can't seem to find any spots that are bad in the wiring. I am hoping for some direction. Thanks} |
Loki
| Posted on Tuesday, September 17, 2013 - 02:08 am: |
|
check the relay(flasher unit) ? Mine goes afu after I wash the bike. After it dries out, its good to go. (Message edited by loki on September 17, 2013) |
Servinghimdaily
| Posted on Tuesday, September 17, 2013 - 06:05 pm: |
|
Ok. So I got a new flasher relay. 12V from autozone. Same 3 pin setup. Plugged it in a wow turn signal. Tested both sides 2x's. Success. Then they quit working. How do I know if I fried the relay? If it did, why?\black{}} |
Roderick
| Posted on Tuesday, September 17, 2013 - 06:58 pm: |
|
I installed LED turn signals on my S1 and the Guilera EP 34 have been working fine. Roderick |
|