Author |
Message |
Rde48
| Posted on Thursday, July 29, 2010 - 11:39 am: |
|
I need a seat bolt for an s3. Does anyone have an extra or know the part # for one. Not sure if it would work with just a bolt from the hardware store. Thanks |
Jramsey
| Posted on Thursday, July 29, 2010 - 11:52 am: |
|
The barb end with the groove measures 1/2", the threaded shank is 7/16" x 20. Made and sent one to N.Z. Tuesday. |
Jramsey
| Posted on Thursday, July 29, 2010 - 11:55 am: |
|
BTW the stud is not shown in the parts catalogs but the jamb nut is............ go figure. |
Rde48
| Posted on Thursday, July 29, 2010 - 12:28 pm: |
|
Thanks James What did you make one out of? I will stop at the hardware and pick up a 7/16 bolt and see if I can make that work. |
Jramsey
| Posted on Thursday, July 29, 2010 - 01:20 pm: |
|
Most have been 6061 T6 Aluminum...couple from drill rod. Where the S3 has two latches it shouldn't be too critical what its made of. |
Buellistic
| Posted on Thursday, July 29, 2010 - 05:43 pm: |
|
How about a picture where it goes ??? |
Nukeblue
| Posted on Thursday, July 29, 2010 - 10:21 pm: |
|
i got one you can have |
Rde48
| Posted on Friday, July 30, 2010 - 10:08 am: |
|
Pm sent Nukeblue Thanks everyone else! |
|