G oog le BadWeB | Login/out | Topics | Search | Custodians | Register | Edit Profile

Buell Forum » XBoard » Archive through November 28, 2011 » Spark Plugs Fouling? « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Arens123
Posted on Tuesday, November 22, 2011 - 07:18 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Alright guys i'm new here and to be honest not a mechanical genius :P so here is my predicament. My XB12 recently fouled its spark plugs which I replaced. Well after a single 20 mile ride, they were fouled again... All of this happened after I switched the stock exhaust to a Jardine Gp-1. This has me perplexed and the only reason I could think for this is that the fuel mixture is too enriched? Would that be an ECM problem? Thanks for any and all help guys!!!
Top of pagePrevious messageNext messageBottom of page Link to this message

Terrys1980
Posted on Tuesday, November 22, 2011 - 08:53 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

It's highly unlikely that it would be too enriched after putting a free flowing exhaust on it.

You would need to check the afv, that would tell you if it is running rich or lean.

Here are some tips to prevent fouling.
1. When you start the bike let it warm up completely before taking off.
2. Don't rev or blip the throttle while the bike is warming.
3. Don't start and stop the bike repeatedly.

How often have you been riding it before you put the exhaust on?

How much has the temperature dropped up there lately?
Top of pagePrevious messageNext messageBottom of page Link to this message

Dcmortalcoil
Posted on Wednesday, November 23, 2011 - 01:39 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Plug also fouls if you do city riding - taking short trips. killing engine, restarting frequently.
Top of pagePrevious messageNext messageBottom of page Link to this message

Boliver
Posted on Wednesday, November 23, 2011 - 06:35 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Not that I am proud of it but I got 28,000 miles out of a set of plugs. BTW I have never touched the throttle upon start up or until the bike has fully run for no less than 5 minutes. And the 5 minute warm up applies to Summertime in Oklahoma.

IMHO plugs DO NOT foul from city riding. Maybe parade riding but not city. Well at least not on my 2005/33,000 mile bike
Top of pagePrevious messageNext messageBottom of page Link to this message

Arens123
Posted on Wednesday, November 23, 2011 - 09:22 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Well I put the new exhaust on after about 2,000 miles and it currently has 4,500 on it. I do always let it warm up for at least five minutes before any ride, but to answer about the temperature, in the past few weeks here in Ohio we've had everything from mid 70's to low 30's and it keeps going up and down.
Top of pagePrevious messageNext messageBottom of page Link to this message

Terrys1980
Posted on Thursday, November 24, 2011 - 09:21 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

You might want to look into getting ECMSpy cable and software. If you could find out your AFV that would tell us/you a lot.
Top of pagePrevious messageNext messageBottom of page Link to this message

Bike_pilot
Posted on Thursday, November 24, 2011 - 01:00 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

I ride in DC in rush hour every day and have never fouled a plug on the Buell or anything else. If plugs are fouling on a four stroke something is seriously wrong with either the mixture or the spark. Bad wires/coils can give a weak spark and then plugs will foul easily.
Top of pagePrevious messageNext messageBottom of page Link to this message

Greg_e
Posted on Thursday, November 24, 2011 - 05:35 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

It could also be burning oil from bad valve stem seals.
Top of pagePrevious messageNext messageBottom of page Link to this message

Firemanjim
Posted on Monday, November 28, 2011 - 01:45 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Or the engine temp sensor is wonky telling bike it is cold and adding a ton of fuel.
« Previous Next »

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a public posting area. Enter your username and password if you have an account. Otherwise, enter your full name as your username and leave the password blank. Your e-mail address is optional.
Password:
E-mail:
Options: Post as "Anonymous" (Valid reason required. Abusers will be exposed. If unsure, ask.)
Enable HTML code in message
Automatically activate URLs in message
Action:

Topics | Last Day | Tree View | Search | User List | Help/Instructions | Rules | Program Credits Administration