G oog le BadWeB | Login/out | Topics | Search | Custodians | Register | Edit Profile

Buell Forum » XBoard » Archive through May 25, 2010 » Race ecm « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Migs16
Posted on Tuesday, May 11, 2010 - 11:54 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

how do you everyday riders like the race ecm on ur bike?? is it worth it for the power gain or not?
Top of pagePrevious messageNext messageBottom of page Link to this message

Lighninginthesky
Posted on Wednesday, May 12, 2010 - 12:14 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

Now there is no need to buy the race ECM. I think the race ECM is mapped for the Buell race kit, including race pipe and air filter. Before ECMspy you needed the race ECM not to have the check engine light on continuously after removing the exhaust servo for the stock exaust. Now with ECMspy you can just turn off that function. No need for the race ECM. All said you should probable have you ECM remapped for your. jardine exhaust. That is how I understand it.
Top of pagePrevious messageNext messageBottom of page Link to this message

Migs16
Posted on Wednesday, May 12, 2010 - 12:44 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

really ok thanks about that. i am hearing so much about jardine pipes. y does everyone hate them and what makes them so bad??
Top of pagePrevious messageNext messageBottom of page Link to this message

Terrys1980
Posted on Wednesday, May 12, 2010 - 01:32 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

The Jardine exhaust is not bad for the 9 but the 12 is a different story. The Jardine is too free flowing for the 12. According to the American Sport Bike dyno charts the Jardine is one of the best performing pipes for the 9. Some people bad mouth the Jardine because of the loss of low end torque due to the lack of backpressure. This can be fixed with a quiet insert or tuning or by fitting a reducer inside the can itself.
Top of pagePrevious messageNext messageBottom of page Link to this message

Andymnelson
Posted on Wednesday, May 12, 2010 - 11:52 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

There is SOME accurate info above.

If you do not understand ECMSpy, the race ECM is a good plug-and-play option for you.

Only the 12 had the valve in the muffler, the 9 did not.

The race ECM works fairly well with most pipes.

To answer your question directly, I don't mind the mapping in the race ECM. You do lose some lower rpm drivability, but I came from the sport bike world so keeping the bike in the higher rpms is not a big deal to me.
Top of pagePrevious messageNext messageBottom of page Link to this message

Lighninginthesky
Posted on Wednesday, May 12, 2010 - 01:55 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

Thanks now I have learned a bit as well.
Top of pagePrevious messageNext messageBottom of page Link to this message

Migs16
Posted on Wednesday, May 12, 2010 - 01:55 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

really ok thanks alot for the info on the jardine becasue it was really getting to me how bad they were. but il do some more reserch on the one i have and see if i can get it tuned.

thanks
Top of pagePrevious messageNext messageBottom of page Link to this message

Xoptimizedrsx
Posted on Thursday, May 13, 2010 - 11:55 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

I'm with Terry from the above statment... (xb9 good, xb12 no good, terrible, ect.)
Top of pagePrevious messageNext messageBottom of page Link to this message

Grindgearz
Posted on Friday, May 14, 2010 - 03:13 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

I have that set up but cant compair i was lucky to buy it that way. its very torquie enough to where i dont thing u could tell the difference. its loud as F!@#$%& LOUD! i have no problem parting the way down I80.
Top of pagePrevious messageNext messageBottom of page Link to this message

Slaughter
Posted on Friday, May 14, 2010 - 10:04 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

I think the main strike against the Jardine is they have a reputation for coming apart.
Top of pagePrevious messageNext messageBottom of page Link to this message

B00stzx3
Posted on Friday, May 14, 2010 - 10:24 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

Mine blew apart at around 8k. Turned the end and re-riveted. No biggie. Until I have the $$$ for a Jardine or those equal length janks, it works fine!
Top of pagePrevious messageNext messageBottom of page Link to this message

Terrys1980
Posted on Friday, May 14, 2010 - 11:09 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

I think on the coming apart deal could be partially self inflicted. It could easily be caused by improper tightening of the system when installed, not repacking in intervals e.g. 5000k miles and the can being hit from bottoming out. As the packing wears out to a point where its almost gone, the exhaust gases put a lot of pressure on the end cap causing the blow out.
Top of pagePrevious messageNext messageBottom of page Link to this message

Patrickmitchell
Posted on Friday, May 14, 2010 - 12:55 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

I have a race ECM and a Jardine can on my XB9SX. Both have been nice upgrades. My opinion is that the race ECM makes the bike a little less friendly/easy to ride on the street. It was MUCH better at the track. It is really loud (more than I would like).

American Sport Bike has a great review/tests of the various exhausts that are available for Buell XBs. On my 9, I have had no quality issues with the Jardine can.

(Message edited by PatrickMitchell on May 14, 2010)
Top of pagePrevious messageNext messageBottom of page Link to this message

Raymondt
Posted on Friday, May 14, 2010 - 02:28 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

I rode a stock bike and a factory kitted bike and went for the factory kit. I have had the factory race kit including the ECM since new on my 12S I am at 26,000+ miles with no issue, and it has been a good all around performer with out too much noise. Sometimes I wish it sounded like a Sportster with straight pipes, but I wear ear plugs already! Can anyone with ECM Spy copy my Race ECM settings to my stock ECM so I would have a spare?
Top of pagePrevious messageNext messageBottom of page Link to this message

Bitbear
Posted on Friday, May 14, 2010 - 03:32 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

I love my factory race kit (pipes, intake, ECM) on my '03 XB9s.

It might be a tad rougher at the low end, I'm not even sure it's noticeable, but Jeez does it wind up nicely and smoothly. Noticeable performance increase and sweet (hefty but not deafeningly loud) sound.
Top of pagePrevious messageNext messageBottom of page Link to this message

Sifo
Posted on Friday, May 14, 2010 - 06:20 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

I'm quite happy with my Jardine on my XB12. It did run rich in the bottom end until I got the tuning done. The torque hole was very noticeable without the tune.

It's seen of 20K miles so far with no problems other than the occasional repack. I do have the CF version so that may be a factor in durability. I've also heard that decel popping beats the rivet holes up pretty bad, compounded by not repacking it.

I find it to be a reasonable muffler for the cost. I do have the QT baffle though. Too loud without it!
Top of pagePrevious messageNext messageBottom of page Link to this message

Metalstorm
Posted on Sunday, May 16, 2010 - 07:57 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

I had a race ecm on my 05 cg.

What it did was provide a much better timing curve that worked with the stock timing setting.

When she was all stock the timing never seemed right and I had to retard it a teeny bit. With the race ecm however, she liked the timing mark dead center where it's supposed to be.

It worked well with the Buell race pipe and K&N.

The real magic happened when I added the open air box kit and tossed the race can for an SS Drummer.

My bike instantly evolved into an absolute joy to ride at any speed and any rpm.
Top of pagePrevious messageNext messageBottom of page Link to this message

Team_ruthless
Posted on Tuesday, May 18, 2010 - 12:23 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

anyone notice e.b.r. is selling ecms programmed for jardine exhaust now? wonder how those perform.
Top of pagePrevious messageNext messageBottom of page Link to this message

Terrys1980
Posted on Tuesday, May 18, 2010 - 01:21 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

I would like to see the fuel maps for that ecm.
« Previous Next »

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a public posting area. Enter your username and password if you have an account. Otherwise, enter your full name as your username and leave the password blank. Your e-mail address is optional.
Password:
E-mail:
Options: Post as "Anonymous" (Valid reason required. Abusers will be exposed. If unsure, ask.)
Enable HTML code in message
Automatically activate URLs in message
Action:

Topics | Last Day | Tree View | Search | User List | Help/Instructions | Rules | Program Credits Administration