Author |
Message |
Xoptimizedrsx
| Posted on Saturday, February 07, 2009 - 05:38 am: |
|
ANYONE HAVE STOCK BIKE SHEETS ON THE XB9 LATE AND EARLY MODELS. I REALLY NEED A 2003 STOCK, A 2007, A 2008 AND 2009. I HAVE ALL THE ENGINE DATA. KNOWING NO TWO RUNS ARE ALIKE I WANT TO OVER LAY THEM AND TAKE A LOOK AT SOMETHING. TEST IT AND POST HERE WHAT I FIND. |
Jramsey
| Posted on Saturday, February 07, 2009 - 05:56 am: |
|
Do you always yell or are your caps lock stuck? |
Texastechx1
| Posted on Saturday, February 07, 2009 - 02:10 pm: |
|
hahahahahaha |
Xoptimizedrsx
| Posted on Saturday, February 07, 2009 - 06:25 pm: |
|
ITS STUCK. SOME BODY AGE 39 SPILLED SOMETHING ON IT. I'LL GET IT FIXED SOON. WAS FUNNY THOUGH. (WISPERING) MIKE |
Dongalonga
| Posted on Saturday, February 07, 2009 - 06:28 pm: |
|
wHispering with an H.... ; ) |
Spacewolf
| Posted on Saturday, February 07, 2009 - 06:46 pm: |
|
Lookout, it's the spelling police. The grammar police will probably arrive shortly too. |
Slaughter
| Posted on Saturday, February 07, 2009 - 07:02 pm: |
|
quote:Lookout
A "lookout" is a noun - as in "A lookout was posted to ensure this thread only uses proper spelling." HOWEVER - "Look Out" - is a command as in: "Look out, it's the spelling police. The grammar police will probably arrive shortly too." |
Skinstains
| Posted on Saturday, February 07, 2009 - 07:15 pm: |
|
I have dyno-sheets for an 03 XB9R stock and with a race muffler, K&N, and race ECM. The bike had 12 miles on it when it went on the dyno. I can mail them to you but don't know how to do it electronically. PM me an address if you're interested. |
Spacewolf
| Posted on Saturday, February 07, 2009 - 11:03 pm: |
|
Slaughter, that is correct, unless the person you are addressing is the lookout. "Lookout, it's the grammar police." Same as "Slaughter, it's the grammar police". It's addressing one by one's title. Interestingly, correct grammar for it should read: Look out! It's the grammar police! That wasn't my intended use of the word tho, and I'll have to concede you were right in the correction. |
Xoptimizedrsx
| Posted on Sunday, February 08, 2009 - 07:51 pm: |
|
sure i sent a "PM". these maps will go with the maps i have already. still needing newer years maps stock dyno runs. with a pipe or not. what i'm looking at it timing data. fuel I'm not concerned with. I want to build a new starter map from all the bikes data not just one bike then post it here for everyone. if you go through the years bike ecm versions you will see fuel and timing change but engine parts didnt. dyno runs on each year all overlaid will help post the best timing curve. then all we do is set fuel. fuel will depend on the bike. yes i can make it all on one bike but a good starting point is data gathered from many. mike |
Frosty
| Posted on Wednesday, February 11, 2009 - 06:45 pm: |
|
Mike I have my factory data saved on sd card 07 XB9R |
|