|Posted on Saturday, December 09, 2017 - 03:36 pm: ||
I want to mount a switch in the right controls where the heated grip control would be. Any idea if I could use a turn signal switch or if I would be better off going a different route? I want an on/off/on switch that looks stock.
Is the heated grip switch a resistor to control heat levels?
(Message edited by Imblasted on December 09, 2017)
|Posted on Monday, December 11, 2017 - 09:51 am: ||
The stock controller has low and high setting.
One position goes to half the element and one position goes to all of the heating element. It looks like a 3 wire plug that would do just that.
There are quite a bit of Buell heated grip parts currently on your favorite auction site for cheap.
(Message edited by terrys1980 on December 11, 2017)
|Posted on Monday, December 11, 2017 - 10:36 am: ||
Okay, creepy! How did you know that was my favorite auction site?!
I have been searching for that part for far too long and I feel dumb for not putting Ulysses when searching.
Edited bc I canít read
(Message edited by Imblasted on December 11, 2017)
|Posted on Monday, December 11, 2017 - 11:06 am: ||
This 24" monitor is great!