Author |
Message |
Sportster_mann
| Posted on Sunday, November 27, 2011 - 02:43 pm: |
|
I have just acquired a 6mm brake disc and fitting kit and have a question - which way round does it fit ? There is no dot on it to match up to the tyre valve and the "tabs" where the disc bolts up to the wheel are recessed on one side - do these recesses go to the outside or inside edge ? The instructions for the fitting kit implies that the recesses go to the outside edge so they are visible when fitted - but I just want to be sure. |
Jdugger
| Posted on Sunday, November 27, 2011 - 05:18 pm: |
|
Recess to the outside, and the rotor doesn't have a balance point, so any match up of tabs to mount points will do. |
Sportster_mann
| Posted on Monday, November 28, 2011 - 09:11 am: |
|
Thanks ! Luckily, just as I thought ... |
Jdugger
| Posted on Monday, November 28, 2011 - 09:17 am: |
|
The EBR rotors are a nice upgrade over stock. So is the mounting hardware. If you have pulsing issues, do you have a DTI to measure run-out on the wheel? |
|