G oog le BadWeB | Login/out | Topics | Search | Custodians | Register | Edit Profile

Buell Forum » Big, Bad & Dirty (Buell XB12X Ulysses Adventure Board) » BB&D Archives » Archive through January 30, 2008 » Bath time! How do you bathe your Uly? « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Ulyganfreedom
Posted on Monday, January 28, 2008 - 10:50 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

So when bath time comes... Bubble bath and a rubber ducky?
I don't want to mess anything up. Are power washers ok.
Thanks...
Top of pagePrevious messageNext messageBottom of page Link to this message

Wolfridgerider
Posted on Monday, January 28, 2008 - 10:55 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

spray it down with S100 and go for a ride in the rain......





S100 + hose + towel = 15min. (30 min. if you clean the wheels real good
Top of pagePrevious messageNext messageBottom of page Link to this message

Electraglider_1997
Posted on Monday, January 28, 2008 - 11:57 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

My 06' is a bit shy so it rarely takes a shower.
Top of pagePrevious messageNext messageBottom of page Link to this message

Ft_bstrd
Posted on Monday, January 28, 2008 - 11:59 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Avoid power washers. They are bad for bearings.
Top of pagePrevious messageNext messageBottom of page Link to this message

Chrisb
Posted on Monday, January 28, 2008 - 12:32 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

+1 Power washers are a NO NO

I have been known to hit the car wash during the winter months for a "controlled rainstorm" I keep the wand tip 5ft away from any part on the bike.
Top of pagePrevious messageNext messageBottom of page Link to this message

Chadhargis
Posted on Monday, January 28, 2008 - 12:56 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

When I wash it with water, I use a mild soap and a wash mitt. I use a soft bristle brush to get into the cooling fins and crevices.

Otherwise, I use Honda Polish. Spray on, wipe off.
Top of pagePrevious messageNext messageBottom of page Link to this message

Ikeman
Posted on Monday, January 28, 2008 - 12:58 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

+1 to Wolfridgerider.
Top of pagePrevious messageNext messageBottom of page Link to this message

Spike
Posted on Monday, January 28, 2008 - 01:08 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Pressure washers are generally shunned, but I've used them on dirt bikes for knocking off the loose dirt without an issue. The trick is to keep your distance and avoid the sensitive areas. Having said that, a sponge and a bucket of water is much better idea for washing your XB.

I use S100 and a hose for quickie wash jobs, but to really get things clean you have to scrub a bit. My normal routine is to spray the tough areas with S100, then use a bucket and a sponge to wash it just like I would my car.
Top of pagePrevious messageNext messageBottom of page Link to this message

Ziftron3
Posted on Monday, January 28, 2008 - 01:17 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

I use only pure rainwater, applied at terminal velocity on the vertical plain, 65mph on the horizontal.
Top of pagePrevious messageNext messageBottom of page Link to this message

Strokizator
Posted on Monday, January 28, 2008 - 02:18 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Best part of the Uly is that I rarely have to wash it (the sole reason I got the orange color). When I do wash it I just throw a bucket of sudsy water at, go over it with a mitt and then rinse it down.
Top of pagePrevious messageNext messageBottom of page Link to this message

Mikej
Posted on Monday, January 28, 2008 - 02:22 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

I've never had any issue with using a pressure washer at a commercial car wash do it yourself place. I just avoid any direct spraying at any sensitive areas as noted by Spike above. YMMV.
Top of pagePrevious messageNext messageBottom of page Link to this message

Supertoon
Posted on Monday, January 28, 2008 - 03:00 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

I find the wheels hard to wash, lots of nooks and I was spoiled with my last bike having a center stand. Also I have opened my finger up twice on the leading edge of the front brake rotor. Watch that bugger, its sharp! Should take a bit of sandpaper to it. Have never used a pressure washer, all in all a easy bike to clean!
Top of pagePrevious messageNext messageBottom of page Link to this message

Chrisgrant
Posted on Monday, January 28, 2008 - 04:22 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

S100?
Top of pagePrevious messageNext messageBottom of page Link to this message

Ratbuell
Posted on Monday, January 28, 2008 - 06:22 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Pressure washers are also bad for electrical sensors and connections. My bikes usually get splashed/mitted with a 50/50 mix of water and simple green (only a COLD bike, nothing hot), garden hose to rinse, and either blow dryer or quick ride around the block to get the water off. In between dustings get spritzed with Harley Gloss or similar quick detailer.
Top of pagePrevious messageNext messageBottom of page Link to this message

Panhead_dan
Posted on Monday, January 28, 2008 - 07:25 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

"Bath time! How do you bathe your Uly?"

Annually, but only if necessary.
Top of pagePrevious messageNext messageBottom of page Link to this message

Hoon
Posted on Monday, January 28, 2008 - 07:28 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Some of you will know what my answer is going to be:

Wash it? I'd rather shove bees up my arse!
Top of pagePrevious messageNext messageBottom of page Link to this message

Danger_dave
Posted on Monday, January 28, 2008 - 07:57 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Fortunately the rest of us have a different buzz.

Garden hose, brush and a bucket of meguires.

Never had another bike like it - 10 minutes from covered in crap to clean.

No bright finishes is the way to go.
Top of pagePrevious messageNext messageBottom of page Link to this message

Bigdaddy
Posted on Monday, January 28, 2008 - 07:58 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

I'm with Mr. Panhead and avoid it at all costs.

I was kind of with Hoon until he got to the bees : )

I like Greased Lightning for super dirty parts if it does get a bath, but never let it get anywhere near a bearing.

I like to use my pressure washer to spray the plugs in my Tomahawks (ask FtB he'll know what I'm talking about : ) )

G2
Top of pagePrevious messageNext messageBottom of page Link to this message

Hdbobwithabuell
Posted on Monday, January 28, 2008 - 10:40 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

"No bright finishes is the way to go."
That's why I traded my fully chrome plated HD Ultra for a Uly.
The only things you REALLY want to keep CRAP off, is the heads. Heat can bake on some road grime. Yeah, that's right... I'm a clean freak.
Top of pagePrevious messageNext messageBottom of page Link to this message

Us_uly
Posted on Monday, January 28, 2008 - 11:20 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

+1 S100.
Top of pagePrevious messageNext messageBottom of page Link to this message

New12r
Posted on Tuesday, January 29, 2008 - 01:15 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Ride in the rain.

I found washing my Buells upsets them and they get real fussy after a wash, front cylinder is usually fouled after the garden hose incidents so I just leave em dirty!
Top of pagePrevious messageNext messageBottom of page Link to this message

Cityxslicker
Posted on Tuesday, January 29, 2008 - 04:51 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Get covered in thick chunky MUD, run through the puddles, ride in driving rain, and for that extra crisp "clean" run in the hard pack snow. The only time she gets "washed" is when the techs need to fix something, or the Hooter girls are back in town.
« Previous Next »

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a private posting area. Only registered users and custodians may post messages here.
Password:
Options: Post as "Anonymous" (Valid reason required. Abusers will be exposed. If unsure, ask.)
Enable HTML code in message
Automatically activate URLs in message
Action:

Topics | Last Day | Tree View | Search | User List | Help/Instructions | Rules | Program Credits Administration