| Author | Message | ||
     Jersey_thunder |
what rear stand are you guys using with the ebr chain conversion...it has spools on it...pit bull is to narrow | ||
| Tdiddy |
Pitbull make several different widths. I've seen a few 1125s's at the track on them. | ||
| Pizzaboy |
...so do the '09 and '10 bikes!! i wish i had the $$ to buy the chain drive conversion! i am using the standard spool only pitbull rear stand, with the sliders as far out as theyll go... and then i took it and stretched the stand out with my foot and arms.. it fits perfectly. you have to stretch them out by about a 1/2" or 3/4". ....or buy the custom buell one. (Message edited by pizzaboy on August 19, 2010) | ||
| Pizzaboy |
Took a pic this afternoon!  | ||
| Buellrider66 |
Without the chain conversion, you can use the "universal" from Pit-Bull, it lifts from the bottom of the swing arm. http://www.pit-bull.com/Merchant2/merchant.mvc?Scr een=PROD&Store_Code=PBMSA&Product_Code=F0061A-000& Category_Code=rear_stands I meant to say with or without the chain conversion (Message edited by buellrider66 on August 19, 2010) | ||
| D_adams |
Tony, use a floor jack and spread the pit bull stand apart until it fits. | ||
| What_the |
The swingarm lugs should be drilled and tapped on the bottom to accept the Pitbull GP rear stand receivers, which are shown in the photo.  MR | ||
| Duggram |
When I was at E.B.R last week I noticed that the race bikes have an attachment on the bottom of their swingarms that take a pin pitbull. I will be getting the same and using the pitbull axle attachments, I already have the set with the three rollers for the Buell. Sent from my phone in Whitehorse, YT. | ||
| Ron_luning |
Call PitBull up and ask them. I did, and they set me up with a wide spool/standard lifer rear stand designed for idiots with 240-300mm rear tires. It fits the standard spool width on the belt drive swingarm with the spool lifting forks set pretty far inward. There should be plenty of adjustment to accomodate the wider spools on your chain drive. | ||
| Knickers |
My pitbull rear stand was just a hair too narrow for the spools so I put my floor jack between the two sides and spread them out a 1/2" or so. Problem solved and you're left with a stand that still works on other bikes. Didn't seem to do any harm. |
