Author |
Message |
Bmarinac
| Posted on Thursday, June 28, 2012 - 08:54 pm: |
|
Anyone have an owners manual for a 2009 1125r? The link on the home page just freezes... And how do u check the oil on the 2010 motor? My 09 has a 2010 engine... |
Froggy
| Posted on Thursday, June 28, 2012 - 09:12 pm: |
|
It sometimes takes a while to load, but the link does work. You can always use the download button that appears after clicking the link. Here is the 2010 oil check procedure:
quote:Pre ride Inspection: An accurate engine oil check can only be made with the engine at normal operating temperature. 1. With motorcycle on the side stand look at the oil level in the sight gauge. An indicated oil level between the lower and upper lines on the oil level sight gauge is acceptable for safe engine operation. 2. If there is no oil present in the sight gauge lift the motorcycle to a straight up and down position to see if any oil appears in the sight gauge. 3. If oil appears proceed to the Hot Check. 4. If no oil appears place motorcycle on sidestand and add oil in 0.1 L (3.4 fl oz) increments just until you see oil in the gauge and then proceed to the Hot Check Hot Check Procedure: 1. To bring the motorcycle to normal operating temperature, ride the motorcycle for a least 10 minutes and 8 kilometers (5 miles). 2. Park the motorcycle on the sidestand while idling and remove the oil fill plug. 3. Idle the engine one (1) minute. Shut off the engine. 4. Read the oil level in the sight gauge.a. Below the lower line: Add oil in 0.1 L (3.4 fl oz) increments until the level is between the upper and lower lines.b. Between the upper and lower lines: It is safe to operate the motorcycle.c. At (or above) the upper line: Drain oil at 0.2 L (6.8fl oz) increments until the oil level is between the lines. 5. Reinstall the oil fill plug
(Message edited by Froggy on June 28, 2012) |
Bmarinac
| Posted on Friday, June 29, 2012 - 11:18 am: |
|
stupid question but where is the sight glass(bike is new to me and has side fairings)? |
Froggy
| Posted on Friday, June 29, 2012 - 11:25 am: |
|
Lower front of the engine, where the header pipes meet the muffler. I don't know if you will be able to see it with the fairing on. (Message edited by froggy on June 29, 2012) |
Noobuel
| Posted on Saturday, June 30, 2012 - 08:11 pm: |
|
Somebody ^^^^ has been trolling the BikeWalls site. lol |
Steeleagle
| Posted on Monday, July 02, 2012 - 08:15 am: |
|
quote:2. Park the motorcycle on the sidestand while idling and remove the oil fill plug.
I don't recommend removing the oil fill plug while idling! DAMHIK. If you do, let me know how that turns out for you, or if you needed oil dry like I did. I followed the instructions. What could go wrong?} |
Kevmean
| Posted on Tuesday, July 03, 2012 - 07:03 am: |
|
I always remove my dipstick with the bike idling ............ never spat any oil out so far and that's with the level at the top end of full |
|