G oog le BadWeB | Login/out | Topics | Search | Custodians | Register | Edit Profile


Buell Forum » Old School Buell » M2 Cyclone » Archive through April 06, 2010 » Oil Capacity « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Scdobber
Posted on Friday, March 19, 2010 - 02:36 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

My service manual for my 02 M2 states 2.0 qts for a oil change, 4 oz. of oil in oil filter and the remainder of the 2 qts in the oil tank.I took it for a test drive and come back to recheck the oil and it does not even touch the dipstick,so I added a few oz more to get it about a 1/4" above the low mark on the stick.Is the manual wrong? The way I'm checking the oil is by driving the bike about 4-5 miles to warm up good and checking the oil with the bike level and the engine off.

(Message edited by scdobber on March 19, 2010)
Top of pagePrevious messageNext messageBottom of page Link to this message

Schwiiing
Posted on Friday, March 19, 2010 - 03:32 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

The stock dipsticks on the M2 are too short. Full oil should register about where you marked it - 1/4'' above the low mark. Filling it any more than that will have oil puking out your vent lines.
Top of pagePrevious messageNext messageBottom of page Link to this message

Cyclonecharlie
Posted on Friday, March 19, 2010 - 03:34 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

That's the way I do mine. And it takes more than two qts.
Top of pagePrevious messageNext messageBottom of page Link to this message

Devil_car
Posted on Friday, March 19, 2010 - 06:20 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

I agree with Schwiiing. The dipstick on the M2 is too short, and if you fill it to the full mark it will be overfull. Once it's overfull, it likes to puke the excess through the umbrella valves in the heads. If the vents in your head are vented to ambient rather than into the intake (into the intake was the stock configuration), you'll see the oil puking out of the vent. I've heard some people say that an overfull reservoir can cause the oil dipstick to push out, too; although, I've never had this happen.

I usually run mine at exactly two quarts and the oil puking almost goes away, but if I put more than two in, it'll keep puking until the level is just right!

(Message edited by devil_car on March 19, 2010)
Top of pagePrevious messageNext messageBottom of page Link to this message

Buell_bert
Posted on Friday, March 19, 2010 - 08:14 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

After 3 years, 2 qts. and no problems. 2000-2001 M2's. Keep it simple, especially with no worrys.
Top of pagePrevious messageNext messageBottom of page Link to this message

Jayvee
Posted on Friday, March 19, 2010 - 09:39 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

Two quarts on mine just barely barely gets the end of the stick wet, not even a millimeter. Good enough.
Top of pagePrevious messageNext messageBottom of page Link to this message

Scdobber
Posted on Saturday, March 20, 2010 - 01:32 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

Thanks for the info,I knew something was not right,never thought about the dipstick being short.I'll keep it at 2 qts
Top of pagePrevious messageNext messageBottom of page Link to this message

Cyclonecharlie
Posted on Saturday, March 20, 2010 - 09:49 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

The more oil you can run in these bikes the better, but you have to have room for the extra oil:oil coolers,large ford filter or Harley long filter.And if you got money to burn, a Alum.oil tank w/ extra qt. capacity.
« Previous Next »

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a private posting area. Only registered users and custodians may post messages here.
Password:
Options: Post as "Anonymous" (Valid reason required. Abusers will be exposed. If unsure, ask.)
Enable HTML code in message
Automatically activate URLs in message
Action:

Topics | Last Day | Tree View | Search | User List | Help/Instructions | Rules | Program Credits Administration