| Author | Message | ||
     Shadowracerx1 |
My jet coated D&D header cracked. Any thoughts on the feasibility of welding this? Thanx | ||
| Brinnutz |
depends on where it cracked. Take it off, take to a welder and ask? I welded my old race header after it cracked at the weld. It held fine. Well, Smoke welded it...=) | ||
| Shadowracerx1 |
Not at the weld... no such luck. It cracked at the O2 sensor and continued around the pipe. | ||
| Hugie03flhr |
Clean it and welder her up! If it looks weak, weld in some support bans. | ||
| Shadowracerx1 |
*sigh* then the whole re coating... funny thing is I just sold my spare D&D system recently. | ||
| Cobraman |
i had a crack in the header around the O2 sensor on my race headers. I was able to get it welded back up, but was told it was hard to do (his reason for the weld looking so sloppy). | ||
| Shadowracerx1 |
Dunn's Welding of Southfield has done the honors (again). I wish these pipes were easier to install... |
