| Author | Message | ||
     Drfuyutsuki |
Hey all, Laid my bike over in some gravel on the 2nd, and I need a few things to get her going again. New/New to me Bars, still has the stock 7/8" set-up. Turn signal switch, just the switch the rest of the controls are fine. Enricher cable assy, don't know how but the housing cracked on it. I know I am going to need new exhaust seals, and I have one stud I need to pull (I might do all of them while I am at it) I could also use some advice on painting the plastic, paint choices techniques that sorta thing. | ||
| Buelliedan |
I have a set of 98 S1WL bars I would sell for $25 in good shape. | ||
| Bruce_bueller |
MOST ANY 7/8 BARS FROM METRIC BIKES WILL FIT. AS FAR AS PAINT GOES MAKE SURE THAT YOUR PAINTER IS FAMILIAR WITH ABS PLASTIC AND SEALING IT PROPERLY, OTHER WISE YOU WILL GET NOT SO NICE BIG BUBBLES UNDER YOUR PAINT...LIKE I HAD.  | ||
| Drfuyutsuki |
Thanks for the info guys; sorry it took me so long to get back to you my last couple weeks have been busy. I ended up going with a straight length of 6061 aluminum to replace the bars and I love the reach and look of it. I may just end up leaving the front cowle it looks kinda nice with out it. Talk to you all later, Josh |
