| Author | Message | ||
     Xldevil |
Trying to service my swingarm bearings and the rear isolators. The problem is how to get to the upper left nut at the swingarm mount block. How do I have to make me a wrench to loosen this nut? I know it is told how to make it at the ATC side,but I would like to have picture to get it clearer.Iīm no native speaker and I donīt think that I really understood how the wrench should look like. Or can I use a crowfoot? Second,can someone show me how the use the selfmade isolator squeezers during reinstall of the swingarm? Thanks,Ralph | ||
| Gohot |
there is a thread here in the forum for the "Squeez" deally, you have seen it haven you? if you find it, its a simple aparatus you can get the stuff to make at a Ace Hardware. I'v changed the isolaters twice on my bike and it's not as bad as you would think,, if you are a total novice, it may be difficult. Tell you what, pm Me and I'll coach you trough it if need be over the phone, also I'v a post on this subject somewhere in the posts, within the last year and a half....Rich @ GoHot229@yahoo.com or 704-851-9953 after 5  m Eastern time zone or if Close to South Central North Carolina we can meet |
