|Posted on Sunday, April 30, 2017 - 10:18 am: ||
Does anyone know the dimensions for the motor?
Mainly looking for info on height from bottom to top
max width (side to side)
and front to back - from the furthest point on the rear cylinder to front of front cylinder
more project questions...
|Posted on Sunday, April 30, 2017 - 10:36 am: ||
I should be able to get those for you sometime today. Got one sitting on a pallet, just a matter of finding the time to do it.
|Posted on Sunday, April 30, 2017 - 02:05 pm: ||
Man that would be awesome!
Im looking at different ideas
I want to go the drag route, but I have other ideas too
These measurements could help sway me one way or another (or, if I could build both and just swap engines between the two )
|Posted on Monday, May 01, 2017 - 05:33 pm: ||
Looks like 25" high...to the top of the throttle bodies.
Looks like 19" wide to me.
Best I can guesstimate the length as specified is 22.5-23".
At some point in the near future, I should be able to get more precise measurements.
(Message edited by Panshovevo on May 01, 2017)
|Posted on Monday, May 01, 2017 - 07:33 pm: ||
19" at the widest point of the cases?
Wouldnt have guessed it was that wide, but never thought about it.
But the height is a great one to know, just trying to figure out some stuff.
I'll post more as I figure stuff out, but I think you might dig the direction I go based on your handle on here