| Author | Message | ||
     Srosenquist |
just had my drive belt replaced, and 50 miles out my speedo go's crazy, and now only indicates 0 mph and no gear indication? where do i start? | ||
| Zac4mac |
Speed sensor. It's by the dipstick. Check for iron "fuzz". The IC calculates gear from speed and rpm; lose either the VSS or KPS and no gear indicated. | ||
| Srosenquist |
after limited investigation, i also have no horn or brake lights, the parking light works, checked the fuse and it's good. ??? | ||
| Srosenquist |
correction closer inspection #9 10amp fuse was blown, horn and brakes work now, have not road tested for speedo, BUT, fuses dont blow for no reason do they? | ||
| Jdugger |
> fuses dont blow for no reason do they No, but the reason might not be electrical. I've learned to replace my fuses a couple of times a season. I've had a couple fail from the mechanical violence this bike and Texas tracks put on things... | ||
| Srosenquist |
just 2 b sure, the speedo and gear indicator are tied to the brake horn circuit? | ||
| Cataract2 |
Check your wires at the horn. One might be rubbing on the bracket and shorting. Had this happen on mine. | ||
| Neufey |
I had the same thing happen to mine recently, turned out the wires going into the tail light chaffed through on the sub frame behind the rear seat latch. | ||
| Srosenquist |
i changed the fuse and didnt inspect any wires. so faR SO GOOD,. think just vibration killed the fuse |
