Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Paulp1125cr
| Posted on Friday, November 25, 2011 - 11:02 pm: |
|
Hi all, was wondering if anyone had ever takin apart the stock mirrors on a 1125 cr before and if so how did u do it?. Thanks |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Pnw_uly
| Posted on Sunday, November 27, 2011 - 08:49 am: |
|
Put a set on my Uly, did as much as removing and swapping the bases, not much more you can do AFIK, I believe the LED portion is an integral unit that cannot be repaired - - replacement only. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Zac4mac
| Posted on Sunday, November 27, 2011 - 11:57 am: |
|
I took my "R" mirrors apart to try and make them functional. Then I replaced them with Firebolt mirrors. The LED/mirror head looks the same tho, try submerging the glass in boiling water for a minute or so. Gently peel the glass away and you should find a fastener in the center. If it gets hard to peel, put it back in the water for a few seconds.
![](http://www.badweatherbikers.com/buell/messages/290431/659841.jpg) That's the best pic I can find with the glass removed - you can see the fastener in the center. Z |
|