| Author | Message | ||
     Keef |
I got my lowers yesterday and wanted to bolt them on and see what I needed to modify on them to fit my CR and there are no directions supplied,just both fairing sides,stick on insulation,and a yellow bag of hardware, nut,bolts,spacers,clips,etc. Does someone have directions they can scan so I can see the lower brackets mounting points .. | ||
| Jules |
Which lowers are they? | ||
| Keef |
the buell factory ones... | ||
| Furbaby |
If your part number is M2296.1AMMW,post me your e-mail address and I`ll send you a copy of what I`ve got. | ||
| Keef |
stil@kc.rr.com | ||
| Rockstarblast1 |
yep there shoulda been some in the box | ||
| Keef |
dealer said they don't come with instructions....ooookk, first time i have ever seen a buell accessory without directions... | ||
| Justa4banger |
the hardest part would be figuring out a way to get the fairings mounted on the top. post some pics..i'm curious.. | ||
| Keef |
i need to know how the four brackets on the bottoms are supposed to mount then i will figure out what i am going to do at the top.. | ||
| Keef |
mounting the bottom side first then i will measure and modify top needed | ||
| Keef |
finally figured out the bottom got the top taped off got to cut them off sand the upper edge then mount the top gonna leave gloss black for a minute but later want to paint it the frame color black... | ||
| Bobbuell1961 |
Keef, please don't melt your lowers and cry.   | ||
| Keef |
why would i melt the lowers i already got some better insulation and am moving that side lower out 1/4 of an inch extra... | ||
| Bobbuell1961 |
just kiddin' | ||
| Illbuell |
post some pics up when your done  | ||
| Kc10_fe |
For the 1/4 inch do you plan on packing it out with washers or picking up a spacer from the local hardware store? I need to do some adjusting as well and reapply some tape. Its a bummer to find the damage already done. | ||
| Keef |
Grant you washers would be easier but will use spacer when i am done,hell that is the easy part,my 1125 is a CR so there is no fairing to attach to up top,will have to measure and cut with jigsaw then sand to final shape and attach it on both sides at top. I have a couple ideas, one is wellnuts in the pod covers for one 3 across the top and with the two on each bottom it should be fine...has anyone else attempted to put the side fairings on a 1125CR? | ||
| Trafford |
Ref CH00401AM I just today fitted a Fairing set. Came with instructions that says to fit the supplied quarter inch spacer to the right hand side front bracket situated near the exhaust exhaust pipe. There is a photo showing the screw and it writes that the spacer should be fitted but also states that (of course) the spacer can't be seen. I decided to add another, so there are now two between the bracket and engine casing. That meant I had to re-bend the rear bracket slightly to ensure both bracket captive clips lined up with the fairing. It was perfect and the clearance -fairing to pipe looks like it will have enough clearance to avoid melting.....lets see! FYI fairing manufactured July 09 |
