G oog le Buell 1125R Forum | Login/out | Topics | Search | Custodians | Register | Edit Profile


Buell Forum » 1125R Superbike Board » Stator/Voltage Regulator/Charging System subforum » Anyone in the UK/EU had the stator "fix" done? « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Jules
Posted on Monday, April 26, 2010 - 06:09 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

I was just wondering (given there are a couple of threads on the stator fix going on at the moment) whether anyone in the UK (in particular) or Europe in general has had the stator fix applied and a new flash?

I'm in for my first service next week and would like to get them to order the parts (knowing they are on backorder) but I never received a letter from HD.

As per my other thread they'll have to order some other bits too (front O2 sensor and new IC) so I'd like to get them all ordered together.
Top of pagePrevious messageNext messageBottom of page Link to this message

Colintornado
Posted on Monday, April 26, 2010 - 03:27 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Jules, I have the harness update,(product program 0507) part 94753Y. The calibration that is needed is the M3HEC142(for europe).If already installed then no flash needed. Basically the new bit of loom is wired in series with the 3 phases of the alternator,one phase is switched via a relay,the relay takes a 12volt supply from the active solonoid connector,the ecu grounds an extra wire to energise the relay,when grounded the relay is energised and the alternator phase is connected (ie all 3 phases),if the instructions in the ecu tell the phase to be dissconnected the the ecu would remove the ground and the relay will switch to open circuit.That has taken me a long time to say ! but it is quite simple really.
colin.
Top of pagePrevious messageNext messageBottom of page Link to this message

Jules
Posted on Monday, April 26, 2010 - 03:51 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Thanks Colin I'll print that out & take it in with me when I go in for the service.

Do you do any of the UK rallies - maybe I can buy you a pint sometime : )
Top of pagePrevious messageNext messageBottom of page Link to this message

Littlebutquick
Posted on Monday, April 26, 2010 - 04:58 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

I HAVE THE LOOM ON BACK ORDER AT BLACKBEAR FOR MY 2009 CR
Top of pagePrevious messageNext messageBottom of page Link to this message

Jules
Posted on Monday, April 26, 2010 - 06:05 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Cool, did either of you get a letter or did you just go in and tell them about this?
Top of pagePrevious messageNext messageBottom of page Link to this message

Sportster_mann
Posted on Monday, April 26, 2010 - 06:15 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

I've got a stator repair kit waiting for me at the dealer's to be installed - they got notification from HD-Net when they entered my VIN at the first service.

Must get it done soon now that the days are warming up.
Top of pagePrevious messageNext messageBottom of page Link to this message

Foxy
Posted on Monday, April 26, 2010 - 07:12 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

can an 08 model be uprated using a stator from an 09 model and retro fitting the new harness and getting it re flashed.
Top of pagePrevious messageNext messageBottom of page Link to this message

Dirty_john
Posted on Tuesday, April 27, 2010 - 02:09 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Jules - my dealer has the kit on order for some time, no recall letter, did you honestly expect one?
Chester HD had already entered my VIN and ordered the part as soon as the "recall" was announced before I got to here about this on this forum.

(Message edited by Dirty_john on April 27, 2010)

(Message edited by Dirty_john on April 27, 2010)
Top of pagePrevious messageNext messageBottom of page Link to this message

Jules
Posted on Tuesday, April 27, 2010 - 02:37 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Nope, I didn't expect a letter (might have been nice though) and it's nice to know there are some pro-active dealers out there.

I'll take the details of it in withthe bike when I pop in next week and see if Cheltenham HD can sort it for me - at least now I know there's no excuse for them not to.

Ta

J
Top of pagePrevious messageNext messageBottom of page Link to this message

Colintornado
Posted on Tuesday, April 27, 2010 - 02:40 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

For whatever reason it was decided to only inform registered owners in the US,all 2009 and 2010 1125`s are eligible and also a 2008 if a new 2009 or 2010 engine has been fitted.
So if not in US you have to request from your dealer.My dealer (the foundry) were already aware when I requested.
Jules,I dont attend rallies,but if we ever meet a pint sounds good!
Top of pagePrevious messageNext messageBottom of page Link to this message

Littlebutquick
Posted on Tuesday, April 27, 2010 - 03:27 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

no letter for me they just told me ,but blackbear have always been 1st class with me
« Previous Next »

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a public posting area. Enter your username and password if you have an account. Otherwise, enter your full name as your username and leave the password blank. Your e-mail address is optional.
Password:
E-mail:
Options: Post as "Anonymous" (Valid reason required. Abusers will be exposed. If unsure, ask.)
Enable HTML code in message
Automatically activate URLs in message
Action:

Topics | Last Day | Tree View | Search | User List | Help/Instructions | Rules | Program Credits Administration