Author |
Message |
Billybob
| Posted on Saturday, April 21, 2007 - 07:57 pm: |
|
what do you all use to plug the holes in the base plate when relocating the oil breather lines thanks |
Typeone
| Posted on Saturday, April 21, 2007 - 11:01 pm: |
|
i wedged some rubber stoppers from Home Creepo in the holes, installed from the bottom up so there's no chance of moving inward. |
Ebuella_virus
| Posted on Sunday, April 22, 2007 - 02:10 am: |
|
Using a measuring caliper, I got the size of the hole and went to the local hardware store. They had plastic plugs in the same spot where they sell cabinet handles, knobs, and the like. They were 40 cents each. I super glued them from the outside and used non-silicate sealant as to not screw up any sensors that read the air. Good luck |
Thelumox
| Posted on Sunday, April 22, 2007 - 06:15 am: |
|
i used the section of hose that i cut off. stuck one end up into one hole, and the other end up into the other hole so that (inside the airbox) it looks like it was originally. |
Cycleaddict
| Posted on Sunday, April 22, 2007 - 11:34 pm: |
|
brilliant lumox , brilliant ! |
Jerseyguy
| Posted on Monday, April 23, 2007 - 09:06 am: |
|
We supply these plugs with the Drummer Catch Can kits.
|
|