Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Mike_lee
| Posted on Friday, May 24, 2019 - 08:03 pm: |
|
does anyone have the install instructions for the updated front isolator? Cannot seem to find the set that shows in detail the orientation and torque values. I recall something about it being installed differently if the stem has the cutout? Also, is it ok to use the 7/16 bolt even though the hole in the mount is 1/2? Where could such a spacer be found if needed? Many thanks |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Upthemaiden
| Posted on Tuesday, May 28, 2019 - 07:54 am: |
|
This is what I used: https://www.ebay.com/itm/1-2-to-7-16-REDUCER-INSERT-SPACER-HEIMS-HEIM-JOINTS/370935106918?hash=item565d748d66:g:QR0AAOSwGWNUWT9b:sc:USPSFirstClass!15146!US!-1
![](http://www.badweatherbikers.com/buell/messages/47623/851651.jpg)
|
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Mike_lee
| Posted on Tuesday, May 28, 2019 - 08:08 am: |
|
thank you Josh |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Upthemaiden
| Posted on Tuesday, May 28, 2019 - 10:30 am: |
|
I've also seen people drill out the isolator to fit the original 1/2" bolt, but that seems excessive with such a cheap and easy solution. |
|