Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
S1owner
| Posted on Wednesday, August 31, 2016 - 10:09 am: |
|
Looking through the manual it says tighten till freeplay is gone and forks turn smoothly then tighten pinch screw? Or since I am using XB triples and stem should I use the XB spec? (Message edited by S1owner on August 31, 2016) |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Phelan
| Posted on Wednesday, August 31, 2016 - 10:39 am: |
|
If you have Timken bearings, use the Tuber spec. If you have XB style sealed bearings, use the XB spec. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
S1owner
| Posted on Wednesday, August 31, 2016 - 11:28 am: |
|
I have timken style tuber bearings and I am assuming same as you |
|