Author |
Message |
Sdw
| Posted on Friday, September 04, 2015 - 10:35 am: |
|
I have bought a new front light pod and a halo kit. Not sure how to proceed with set up. I have already done the running lights to indicator mod so I can use the running lights wiring to power the halo. As the two centre low beams are on permanently I was going to position the Halo's around the full beam (outer bulbs) and remove the bulbs from the low beams so all I have on are the two halo lights for maximum effect. I only use the bike in the day and if I get caught out of an evening I can always use the main beams. Obviously I will have to stick the low beam bulbs back in when it comes to the mot. This is the only option I can think of as if I leave in the low beam bulbs I don't think they will look as good running alongside the halo's. Is this the way forward or has anyone got any better ideas? |
Sdw
| Posted on Wednesday, September 09, 2015 - 05:16 pm: |
|
Half way there! Running lights to indicator done. Halo's going around outer main beams and moving main beam connectors to inner low beam so I can run just halo's and have low beam on when I switch to high beam if that makes sense. Clear sealant used though it shows white until it has gone off.
|
Sdw
| Posted on Thursday, September 10, 2015 - 03:37 pm: |
|
All done! Walk around ... http://youtu.be/nmBBhFN54w4 (Message edited by Sdw on September 10, 2015) (Message edited by Sdw on September 10, 2015) |
Augustus_01
| Posted on Thursday, September 10, 2015 - 03:53 pm: |
|
Very nice, looks great! I want to do a projector retrofit on my CR. How hard was it to take apart the headlights? |
Sdw
| Posted on Thursday, September 10, 2015 - 04:07 pm: |
|
People talked about putting them in the oven which scared me but I just left mine in the hot water closet over night and it just pulled apart relatively easy. |
|