Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Sportymark
| Posted on Friday, May 22, 2009 - 09:29 am: |
|
What size Hex do I need to remove the cap screw in the bottom on the fork (the one sealed with crush washers) I knwo it has to be long but not suer of the size. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Easy_rider
| Posted on Saturday, May 30, 2009 - 05:25 pm: |
|
I'm fighting that myself right now. A 5mm fits it best. Mine is frozen. It's a long reach down, a socket is too big to clear the access hole, and the one 5mm I can find right now barely reaches. Good luck with yours! |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Easy_rider
| Posted on Saturday, May 30, 2009 - 05:29 pm: |
|
Are you replacing the item referred to as a "support ring"? The service manual says to replace it. Dealer gave me a quote of ~$45 each!!! It's a metal washer - I don't see the point! |
|