Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Gohot
| Posted on Sunday, October 19, 2008 - 12:41 pm: |
|
Low speed occasional pop through the carb? and bottom end transition opening throttle from idle up 5 or 6 hundered more RPM, then top is ok, and accelerates very good Carb kit/45 jet @ 450-500 foot altitude , V&H SSR can, S&S air cleaner are the only mods. And I ride moderatly almost all the time. Coil?, connections? Jetting????, any thoughts out there, thanks Rich |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Mbc
| Posted on Sunday, October 19, 2008 - 04:39 pm: |
|
Idle mixture is too lean. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Firemanjim
| Posted on Sunday, October 19, 2008 - 10:11 pm: |
|
Have you taken the plug off the idle mixture adjustment screw and have you changed the slow speed jet yet? A definite must on tube framers. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Gohot
| Posted on Wednesday, October 22, 2008 - 09:35 am: |
|
Goin'a look into these remedys, thanks Guys Also read a simmilar thread where the manifold doughnut was miss installed and not sealing properly, caused the above symptoms too. (Message edited by Gohot on October 22, 2008) |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Gohot
| Posted on Wednesday, October 22, 2008 - 04:55 pm: |
|
Turned out to be a vacum line that was incorectly hooked up |
|