G oog le BadWeB | Login/out | Topics | Search | Custodians | Register | Edit Profile

Author Message   Natek Posted on Tuesday, June 08, 2010 - 05:06 pm:        I changed the oil in my Uly for the first time today (979 miles) both primary and motor oil and adjusted the primary chain which was pretty loose. Now I'm getting a sort or sqeal from the motor at lower RPM's in gear or not. I'm thinking I adjusted the primary too tight?... If it might make a difference I used Valvoline Motorcycle 4Stroke SAE 20W-50 in both holes. Used just 3 quarts to get the levels where the book says in the primary and doing a check as most on here do for engine oil (hot bike running on kickstand). Here is a link to a place online that sells the oil I used: http://www.amazon.com/Valvoline-VV743-4-Stroke-20W -50-Bottles/dp/B0006305C4   Kowpow225 Posted on Tuesday, June 08, 2010 - 05:33 pm:        Primary adjustment would be my first guess but I would start by checking the fluid level... should only be about 1 qt in primary and 2.5 in the engine.   Sifo Posted on Tuesday, June 08, 2010 - 05:35 pm:        My first guess would be the primary chain is too tight. Also make sure you check it at it tightest spot. It's a bit of a PITA, but you don't want it binding in the tight spots. I'm confused by... Used just 3 quarts to get the levels where the book says in the primary and doing a check as most on here do for engine oil (hot bike running on kickstand). I hope that didn't mean 3 quarts in the primary. The primary should only get 1 quart.   Natek Posted on Tuesday, June 08, 2010 - 07:38 pm:        Used only about 1/2 quart in the primary and it brought it up to the bottom of the clutch pack, as the picture in the owners manual shows... I'll check it again before I head home from work.   Nextcorner Posted on Tuesday, June 08, 2010 - 07:43 pm:        When changing primary fluid: Drain, adjust, check o-ring, put the plug back in, dump the WHOLE quart in. The primary fluid level is not extremely critical. If it various by an ounce or 2 its OK. But put the whole quart in and call it good.   Sifo Posted on Tuesday, June 08, 2010 - 08:44 pm:        Should be filled to the bottom of the clutch pack with the bike upright. On the side stand it will spill some out.   Nobuell Posted on Tuesday, June 08, 2010 - 09:22 pm:        My primary ends up at the correct level with a quart installed and the bike upright. I make sure to lean the bike to each side a few times to make sure all of the old fluid is out. It sounds like the chain is to tight to me. Check the adjustment a various points to verify adjustment at the tightest point.

Add Your Message Here Post: -Color- Black Red Green Blue Yellow Purple Orange Cyan Gray White -Font- Arial Courier Symbol Times Verdana -Size- Smallest (-2) Small (-1) Normal Large (+1) Largest (+2) Username: Posting Information: This is a public posting area. Enter your username and password if you have an account. Otherwise, enter your full name as your username and leave the password blank. Your e-mail address is optional. Password: E-mail: Options: Post as "Anonymous" (Valid reason required. Abusers will be exposed. If unsure, ask.) Enable HTML code in message Automatically activate URLs in message Action: