| Author | Message | ||
     Firebolt32 |
I was too lazy to find the thread on here about these-http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?Vi ewItem&ih=011&sspagename=STRK%3AMEWN%3AIT&viewitem =&item=320239344628&rd=1 The blinking assembly on the 9r is a two wire system. Could I wire these in being a three wire system without tripping the blinker module? | ||
| Firebolt32 |
Nevermind...Like a typical guy I didn't read the directions until now and it says for a 3-wire system wired to a 2-wire system cut the ground wire and use the stripped wire.  | ||
| Midknyte |
In the back, run the low filament off the power line of the brake lamp low line. In the front, you can tap off the low beam headlight for the low filament of the signals since the low beam runs all the time. The brown wire of our wiring harness is your ground. You will need to change the connectors on those signals - they are too small. You will also need to drill open the mounting holes a bit for the stalks of those. Connector sizes in my light thread - http://www.badweatherbikers.com/buell/messages/384 2/321363.html?1207757579 |
