Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Tommymac92
| Posted on Saturday, April 17, 2021 - 12:24 pm: |
|
So my rear spark plug quit last season, that was easy enough to replace. There are some videos on removing the front w/o rotating the engine. My only problem is removing the air intake snorkel. I cant seem to feel the bolt that holds it in anywhere and the manual doesn't have anything either. Any help would be appreciated. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
1_mike
| Posted on Saturday, April 17, 2021 - 07:18 pm: |
|
So, so..! Yes, as I recall the manual does state where the fastener is. If you reach up from under the front end, to the left of the snorkel, as I recall, there is a "body" mount type screw on the left side near the opening, outside (not inside). It goes into the front of the frame. You really can't see it, without maybe a mirror and a flashlight, but in general, yea, it's up there. Just feel around up there, you'll feel it. Mike |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Tribalreaper
| Posted on Sunday, April 18, 2021 - 07:07 am: |
|
1Mike you are right , but do not forget about the airtemp sensor is right there to. |
|