Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Jbco2
| Posted on Thursday, August 04, 2016 - 02:51 am: |
|
Greetings folks, first post but a long time visitors to this site. Doing a transplant using a BUELL XB12 motor in a different chassis, Due to backbone interference, I wanted to run the throttle body at 90 deg for sidedraft. I have seen Bottpower do this, After putting the throttle body in the desired position, I faced a whole set of new problem, how to tighten the retainer ring screws was one... Any insight or anyone done this? Thx |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Loose1
| Posted on Thursday, August 04, 2016 - 06:21 pm: |
|
Use a x1 or s3 intake/throttle body. |
|