Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Joesbuell
| Posted on Saturday, June 16, 2007 - 08:29 am: |
|
I have been thinking of fitting an XB dash to my 98 model tuber. It had a cable operated speedo, but because I've got an XB front end theres no way to drive a speedo! Does anyone know if an after market speedo sensor, that runs off of a front or rear wheel be used with the XB dash? I see you can buy a re-calibration unit so is it possible? I hope theres an electronics wiz out there! Or someone who can understand this!!!! Cheers Jodie |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Bad_karma
| Posted on Sunday, June 17, 2007 - 12:18 am: |
|
Jodie I'm not sure where I saw it, maybe J&P but they have a sensor to count the bolt heads on the rear pulley that will drive the digital speedos. If I run across it I will add it here. Good to see that the project is still active. Joe (Message edited by bad_karma on June 17, 2007) |
|