Author |
Message |
Rkc00
| Posted on Wednesday, April 22, 2009 - 07:03 pm: |
|
I have not been able to find my copy of the service manuel for my 06 xb12x. Can someone look up the torque values for the following and post them? Front rotor mounting bolts rear rotor mounting bolts rear pulley mounting bolts Oil drain plug Primary drain plug Thanks Mike Long Island, NY 06 XB12X Red/Black |
Teeps
| Posted on Wednesday, April 22, 2009 - 07:40 pm: |
|
Drain plug(s) spec is 30lb/ft; but don't torque them more than 15lb/ft. Also, use a new o'ring and the recommended thread sealant too. |
Rkc00
| Posted on Wednesday, April 22, 2009 - 07:47 pm: |
|
Thanks. Mike Long Island, NY 06 XB12X Red/Black |
Hammer71
| Posted on Wednesday, April 22, 2009 - 07:54 pm: |
|
Front rotor 25-27 ft/lbs Rear rotor 25-27 ft/lbs Rear pulley 35-37 ft/lbs oil drain 29-31 ft/lbs Primary Drain not sure right now usually same as oil drain hope this helps Mike |
Rkc00
| Posted on Wednesday, April 22, 2009 - 08:10 pm: |
|
Rich, Thanks for the #'s Mike Long Island, NY 06 XB12X Red/Black |
Skinstains
| Posted on Wednesday, April 22, 2009 - 09:01 pm: |
|
DO NOT torque either of your drain plugs to 30 ft/lb. Or anything close to it. You will strip the female threads as many here have done. |
Greenman44
| Posted on Thursday, April 23, 2009 - 11:54 pm: |
|
Skinstains is very true, I have heard new swingarm is over a grand to replace. I have the same bike, think I found it http://www.badweatherbikers.com/buell/messages/384 2/305911.htmlin posting above photos 12-15 lbs as per tech's advice |
|