|Posted on Tuesday, August 22, 2017 - 10:09 pm: ||
I did a lot of searching and I seem to find alot of information and instructions on TPS reset for the XB models, but I can't find any tube frame specific for my S3. Can someone direct me to a tutorial on hardware needed and protocol for a TPS reset? I figure I should probably purchase the stuff needed anyway.
As an alternative, I would gladly ride the bike over to someone's house in waukesha/ Milwaukee area for a reset, or a hands-on tutorial on how to do it with your or my own hardware. I would compensate with money/ beer or whatever.
|Posted on Wednesday, August 23, 2017 - 01:25 am: ||
Sbaugz, you are welcome to come over to my garage and we can do an ECMSpy reset on your bike.
Assume you mean the S3, right.
PM me with contact info and I'll call you in the morning.
|Posted on Wednesday, August 23, 2017 - 10:50 am: ||
I suspect that the TPS reset is similar to the 2007 and earlier xb's
|Posted on Wednesday, August 23, 2017 - 02:27 pm: ||
If you go on this page here: http://thex1files.com/#FI and scroll down just a tiny bit to the "zero the tps" section it should be the exact same procedure as an X1. Hope this helps!