| Author | Message | ||
     S1owner |
Not mine but I know lots look for these  | ||
| Phelan |
Kickin' it old school there. Does it say which model heads it is for? It would behoove the buyer to find out if it doesn't say so. | ||
| Ralph |
It came off of a '99 S3 with Thunderstorms. I was unaware that there were differences.... Can you educate me? | ||
| Purpony |
They also make a billet mount for tube framed bikes that is needed when using XB heads. | ||
| Ebutch |
Even looks like an S2 converted to tuber later models.  | ||
| Ebutch |
Whats XB to Tuber hanger look like ?  | ||
| S1owner |
You could probaly sell it in the classifieds and skip the ebay fees | ||
| Phelan |
A mount that utilizes XB heads looks the same, but the outer hole on the left is ~1/4" inboard compared to the mounts for Tstorm heads. | ||
| Ebutch |
Ok Ross  | ||
| Brother_in_buells |
There is also a engine mount for the xb heads that has one hole slotted. | ||
| Alfau |
Did the weld hold after the repair http://i144.photobucket.com/albums/r200/ebutch/100 _0746-1.jpg (Message edited by alfau on January 19, 2016) | ||
| Brother_in_buells |
Alfau , the cast alloy is difficult to weld! | ||
| Phelan |
Need, yes there is an NRHS mount with a slotted hole to fit both XB and Thunderstorm heads. That is the later NRHS mount. The earlier ones made by Aaron Wilson some years ago look like the one above. | ||
| Phelan |
The later mount  | ||
| Ebutch |
Alf:Yes no problem 25,000 miles and still going.  | ||
| S1owner |
Here is an American Sport Bike one also  |
