| Author | Message | ||
     S1owner |
So what are my choices to run a 61 tooth pulley on an XB wheel? Had my very expierienced welder trying to fill the holes on stock pulley sonI can re drill to fit but the pulley cracked | ||
| Phelan |
Have Marc make you one. Or Rizoma I think makes or made one. No cheap options. Better option is to use the 65t pulley with the XB12 primary gearing to keep the overall ratio closer to stock (4% lower than stock). | ||
| S1owner |
Cant use the stock Xb pulley as Inhave an Xb swingarm also which then I would need a 142 tooth belt which as far as I have found is not obtainable. So I need a 61 hoping Marc will help but its asking alot. | ||
| Phelan |
I suspected that might be the issue. Tough pickle.. Hmm | ||
| Purpony |
funny.. im sitting here tonight sitting on my couch redesigning my XB 61 T pulley for easier machining... the one I made was a PITA that sucks that the pulley cracked on it  | ||
| S1owner |
Dont you mean redesigning our pulley  | ||
| Purpony |
ya ya... finished  | ||
| S1owner |
What was the issue with the other one? | ||
| Phelan |
I'm guessing he just rewrote the program to make machining it take less steps. | ||
| Purpony |
exactly, the one i originally made for my bike had a couple complex radius that made machining a pain- |
