G oog le BadWeB | Login/out | Topics | Search | Custodians | Register | Edit Profile


Buell Forum » Old School Buell » Archive through June 13, 2013 » Oil light blinking and staying on « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Kellenbm
Posted on Tuesday, May 28, 2013 - 08:31 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

I posted about this problem I just need to specify what I have found. I removed the rocker cover of the rear cylinder. I turned the engine over and I noticed the exhaust valve and push rod were not moving. I removed the push rod and cover to check the tappet. It was not moving I double checked it again while turning the motor over. So I removed the tappet, removed the oil filter , checked for metal. I did find a little glitter. Nothing major. Then after removing the cam cover I found no glitter in case. The cams and tappets look fine. But prior to removing the cam case I put the lifter back in and it was moving up and down. So I put it back together but I the oil light came on and did not blink off. And a slight chatter That I can't really be sure what it is. So I stopped and removed the cam case. The Oil pump gear looks perfect as well the cam lobes and tappet rollers. Any clues for me to cure this? Also could it be the tappets lifters? Or what? I did find after further checking that the Oil pump is scoured on the inside of it housing and the gerator gears are scoured also. So I must replace the oil pump.

(Message edited by kellenbm on May 29, 2013)
Top of pagePrevious messageNext messageBottom of page Link to this message

Orngm2
Posted on Tuesday, May 28, 2013 - 08:53 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

pull the oil pump and turn it by hand... i bet you will find a tight spot. take the pump apart and i bet one of the gerators in the pump is cracked or damaged... Ask me how i know : )
Top of pagePrevious messageNext messageBottom of page Link to this message

Oldog
Posted on Thursday, May 30, 2013 - 10:36 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Be sure to check the lines and tank, either low oil or debris damaged the pump....
Top of pagePrevious messageNext messageBottom of page Link to this message

Natexlh1000
Posted on Thursday, May 30, 2013 - 11:23 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Check the roller on your lifter.
My ironhead ate its bearing and chucked a needle into the oil pump.
Shear pins in the oil pump kept the feed side turning but the scavenge side stopped and so my engine filled with oil.
« Previous Next »

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a private posting area. Only registered users and custodians may post messages here.
Password:
Options: Post as "Anonymous" (Valid reason required. Abusers will be exposed. If unsure, ask.)
Enable HTML code in message
Automatically activate URLs in message
Action:

Topics | Last Day | Tree View | Search | User List | Help/Instructions | Rules | Program Credits Administration