| Author | Message | ||
     Red_racing_stripe |
hello, my x1 has an issue with blowing the 20A fuse. i thought it was in the turn signals because it only blows if the turn signal relay is plugged in. so i changed out the entire wiring loom instead of looking for a shorted wire. so now i have the same problem but now the bike wont turn over just clicks when trying to start!! can someone help me please? | ||
| 01x1buell |
battery low, bad ground ,bad connection many things... do you have a factory service manual | ||
| Red_racing_stripe |
yes on a pdf, but it dont give me to many things to look for. | ||
| 01x1buell |
i would start with all the connections by making sure they are all tight no corrosion , and would check/ switch the relays around to see if they are bad. what wiring loom did you change. | ||
| 01x1buell |
according to the fsm the 20 amp fuse is the ignition fuse,everything else is 15 amps and the main is 30.. i would load test your battery,one time my batt died and was clicking when went to start. | ||
| Red_racing_stripe |
changed the main harness from front controls to fuse box to the voltage regulator, i will check the battery the bike has set for three weeks. | ||
| Red_racing_stripe |
it may been a 30 in that spot it runs everything except starter. dash lights turns odometer etc. are all on that fuse | ||
| 01x1buell |
i would check for the battery as i said, and look for worn wires on the way to the turnsignals since you said that was what stsrted the problem | ||
| Two_seasons |
Battery posts connections tight? |
