G oog le BadWeB | Login/out | Topics | Search | Custodians | Register | Edit Profile


Buell Forum » Old School Buell » Archive through September 07, 2012 » X1 running like a blast : ( « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Leonard
Posted on Monday, July 23, 2012 - 09:50 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

I was riding through some unfamiliar roads last night when suddenly there was a loss of power and the bike started putputting like my blast..with less power. Soon enough the engine light came on. Dark road lots of curves and no shoulder..oh joy!! I managed to ride if for another 4 or 5 mile to a gas station. All the while I could see tiny blue sparks come from the rear cylinder. As suspected, the rear cylinder spark plug came loose and was flopping around. Plugged it back in and was so relived to hear the roar or two cylinders : ) Has anyone had this happen before?
Top of pagePrevious messageNext messageBottom of page Link to this message

Hootowl
Posted on Monday, July 23, 2012 - 09:56 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

I don't believe I have. Does it look like the gas came out of the spark plug hole, or do you think it washed down the cylinder? Does your oil smell like gas?
Top of pagePrevious messageNext messageBottom of page Link to this message

Leonard
Posted on Monday, July 23, 2012 - 10:06 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

ooops..just realized that I posted wrong Hootowl, my bad. CORRECTION: The plug did not come loose, just the wire.
Top of pagePrevious messageNext messageBottom of page Link to this message

Hootowl
Posted on Monday, July 23, 2012 - 11:34 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

What that means is that for 4-5 miles, you were spraying fuel into your rear cylinder and it wasn't being burned. Probably most of it was getting pushed out the exhaust, but it is possible that a fair amount made it past the rings. I'd change the oil and filter, just to be safe.
Top of pagePrevious messageNext messageBottom of page Link to this message

Leonard
Posted on Monday, July 23, 2012 - 11:46 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

very good point!..Thanks Hootowl. I'm glad I posted this.
Top of pagePrevious messageNext messageBottom of page Link to this message

Buellistic
Posted on Monday, July 23, 2012 - 10:54 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Properly installed with copper compound torque'ing compound and torqued to 12 ft.lbs. ...
Top of pagePrevious messageNext messageBottom of page Link to this message

Ratbuell
Posted on Tuesday, July 24, 2012 - 07:58 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

I knew Buellistic was particular, but damn...he torques his plug wires??

I had an old V8 in college, used to like to throw a coil wire that I made a little too short. Zip tie around the boot did the trick. Click-zip-done.
Top of pagePrevious messageNext messageBottom of page Link to this message

Leonard
Posted on Friday, August 31, 2012 - 10:46 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

It happened again yesterday..WTH! same wire popped off. Have to get new ones I guess
Top of pagePrevious messageNext messageBottom of page Link to this message

Hootowl
Posted on Friday, August 31, 2012 - 11:40 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Crimp the metal clip in the end of the wire a bit so that it grips the end of the plug better.
Top of pagePrevious messageNext messageBottom of page Link to this message

Jayvee
Posted on Friday, August 31, 2012 - 04:26 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Safety wire that sucker!
Top of pagePrevious messageNext messageBottom of page Link to this message

Leonard
Posted on Saturday, September 01, 2012 - 09:17 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Easier and cheaper solutions : )
Top of pagePrevious messageNext messageBottom of page Link to this message

Hybridmomentspass
Posted on Saturday, September 01, 2012 - 10:49 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

I've actually had my sparkplug come OUT before (still attached to the wire).
I was at a local dragstrip and I launched and instantly it felt wrong.
No power, sounded terrible
I limped it back to my pit expecting the worst, only to realize it was a simple fix.
Im not sure what the cause was, but its happened once in 11 years (with that bike), and that was about 5 years ago.
Top of pagePrevious messageNext messageBottom of page Link to this message

Harleyelf
Posted on Sunday, September 02, 2012 - 10:24 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Zip tie is a much better idea than safety wire. It's wider, so there's less chance of cutting the insulation, and non-conductive so there's no chance of shorting your spark to ground.
« Previous Next »

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a private posting area. Only registered users and custodians may post messages here.
Password:
Options: Post as "Anonymous" (Valid reason required. Abusers will be exposed. If unsure, ask.)
Enable HTML code in message
Automatically activate URLs in message
Action:

Topics | Last Day | Tree View | Search | User List | Help/Instructions | Rules | Program Credits Administration