Author |
Message |
S1owner
| Posted on Monday, April 30, 2012 - 11:31 pm: |
|
Ok put my new worxs in but my res hose is like 14 inches long how do i route it with all the extra hose i have a 96 S1 |
Thejosh
| Posted on Monday, April 30, 2012 - 11:58 pm: |
|
It should run across your VR and mount right above your primary just a centimeter in front of the shift arm, at least that's how I mounted it on my X1 as per the instructions. |
S1owner
| Posted on Tuesday, May 01, 2012 - 07:36 pm: |
|
You have any pics as my original shock only had a 3-4" res hose and mounted on the front shock mount? |
Shapem2
| Posted on Tuesday, May 01, 2012 - 07:46 pm: |
|
Ken - check your email. Pics sent |
Daveswan
| Posted on Tuesday, May 01, 2012 - 09:25 pm: |
|
The stainless line is bare, so be careful routing to keep it from sanding away any finished spot. The Penske uses a coated or shielded hose. I mounted my Works shock as picture in their literature. The hose runs up and clears everything. so far so good as pictured when you click on my name. Also have installed the new Y exhaust hanger not shown without interference. |
S1owner
| Posted on Tuesday, May 01, 2012 - 10:47 pm: |
|
Yep thats where shape mounted his also i was just thrown off because the original one mounted at the front shock mount! I am going to wrap the hose as i noticed right off it is close in two spots and i do not need all my hard work worn away. Thanks for the help |
Dannybuell
| Posted on Wednesday, May 02, 2012 - 09:56 am: |
|
gpsuspension.com guys put my Penske reservoir on the horizontal tube near the VR. There is a zip tie keeping the bowed line near the bike. |