| Author | Message | ||
     The4ork |
im asking because whomever made mine did not do a very good job... thinking about starting over for the rear | ||
| Guell |
hals used to | ||
| Phelan |
The next time I do this conversion, I'm gonna make a one-piece adapter because with the right width I'm pretty sure the stock rear caliper bracket will fit unmolested if there's no shoulder from the adapter. Basically it'll be an aluminum sleeve that slides into the wheel from the right, with only a shoulder on the right. | ||
| Guell |
the spacers i have were run on a sluminum swingarmed m2, dont know if anything else was cut or not | ||
| The4ork |
The problem I have is the rear caliper bracket :/ | ||
| Brother_in_buells |
Here are some stainless steel spacers (at the bottom of page) http://www.bareknucklechoppers.com/builderparts.ht ml | ||
| Guell |
im not so sure those are for tubers but it could be a starting point. Id measure mine if i had a mic |
