G oog le BadWeB | Login/out | Topics | Search | Custodians | Register | Edit Profile


Buell Forum » Old School Buell » Archive through August 14, 2010 » S1 squeal when clutch released « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Dan9460
Posted on Tuesday, July 27, 2010 - 07:07 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

Occasionally when I let the clutch out I get a squeal almost as if I had popped the clutch and spun the rear wheel (I know I didn't do that because rpms are low)..any ideas - clutch works well, trans shifts smooth etc..running formula plus primary fluid. 1997 S1
thanks in advance
Top of pagePrevious messageNext messageBottom of page Link to this message

Buellistic
Posted on Tuesday, July 27, 2010 - 07:26 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

Have you replaced the SPRING PLATE(aka GRENADE PLATE) PN37977-90 with two steel and one fiber plates yet ???
Top of pagePrevious messageNext messageBottom of page Link to this message

Dan9460
Posted on Tuesday, July 27, 2010 - 07:43 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

I am not sure - haven't been into it yet..was planning on the kit from American sportbike (5491 includes 8 steel plates and 9 Friction plates for an additional 12% more friction area)
http://www.americansportbike.com/shoponline/ccp0-prodshow/5490.html

But wanted to be sure if what the fix was?

(Message edited by dan9460 on July 27, 2010)
Top of pagePrevious messageNext messageBottom of page Link to this message

Mick
Posted on Tuesday, July 27, 2010 - 08:02 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

May be the belt , I get that occasionally when its cold.
Top of pagePrevious messageNext messageBottom of page Link to this message

Buellistic
Posted on Tuesday, July 27, 2010 - 08:22 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

Al has good stuff !!!

While you are in there replace BEARNG(like a throw out bearing on a STD. CAR/TRK TRANS) PN 8885 ...

Check the PINS on SHIFTER DRUM ASM. PN 33634-91 for looseness(all should be tight) ...

Take a good look(check out) the SHIFTER SHAFT ASSEMBLY(wear on PLATE,detent and up-date to PN 33656-90A), looseness, and the RETAINING RING(clip) PN 1101ness ...

If you want some HELP "INFO", PM me so that "i" can get your e-mail address and it is yours ...
Top of pagePrevious messageNext messageBottom of page Link to this message

Dan9460
Posted on Tuesday, July 27, 2010 - 08:25 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

Thank you so much

pm sent
« Previous Next »

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a private posting area. Only registered users and custodians may post messages here.
Password:
Options: Post as "Anonymous" (Valid reason required. Abusers will be exposed. If unsure, ask.)
Enable HTML code in message
Automatically activate URLs in message
Action:

Topics | Last Day | Tree View | Search | User List | Help/Instructions | Rules | Program Credits Administration