| Author | Message | ||
     Dinuns1 |
HEY IM LOOKING TO BUY A REAR CALIPER BRACKET FOR THE 4 PISTON CALIPER THEY OFFERED ILL BUY THE WHOLE KIT IF THATS WHAT YOU HAVE BUT IM ONLY AFTER THE BRACKET . ANY ONE GOT ONE LAYING AROUND | ||
| Ztferrari |
put this in parts wanted...I meAN..PUT THIS IN PARTS WANTED SECTION (Message edited by ztferrari on May 18, 2010) | ||
| Dinuns1 |
thanks im gonna do that also . just tryna get more visability. | ||
| Jayvee |
Well, I got the PM bracket laying around, but I want to make sure I'm not going to use it for a PM 2-piston caliper. Let me dig it out, and send you a picture. | ||
| Dinuns1 |
pm sent jayvee | ||
| Dinuns1 |
bump | ||
| Jayvee |
oh boy, if it's not a flat tire on my car, it's the camera battery dying. New one is $50 by the way. Here's picture of the original PM bracket, and then what I actually wound up with:   | ||
| Dinuns1 |
pm sent jayvee | ||
| Jayvee |
bracket sent to Dinuns1 yesterday... | ||
| Brinnutz |
Nice, I might use that as a design for my bracket as it's the same as the new one you pictured...I like the cut-out version much better, looks less bulky. | ||
| Jayvee |
If I had it to do over again, which I sort of do, but not right now, due to lack of money, is use one of these calipers (this one went for $82 on ebay earlier this week):  But I'd have to start over with the dagnab bracket, and this one cost me enough as it is. So what I have will have to do for now, but it does work real well. Have to re-train your brain not to 'stand on it' though. I use it a lot in traffic, when I can make leisurely stops, and it's good practice. Save my front pads for when I need to stop in a hurry. (Message edited by jayvee on May 26, 2010) |
