| Author | Message | ||
     Tod662 |
Have done everything by the manual to pull the primary chain and sprockets off. Engine nut is removed and clutch end is free. How do I use a puller to pull the engine sprocket off. The sprocket has 4 drilled nonthreaded holes. Unless if I am missing something obvious, how do you use a puller with no treads (on the sprocket) | ||
| Gowindward |
Pull it and the clutch basket together at the same time by hand. (I'm guessing the primary chain is still on) The magnets in the rotor have a hold on the stator which will make it feel like it is stuck. | ||
| Tod662 |
so its not pressed on?, I tried a little with a bar and it will not budge. | ||
| Jramsey |
It's a snug spline fit, try prying lightly from opposite sides at the same time. | ||
| Gowindward |
Correct, not pressed on. | ||
| Hootowl |
Like it says....do not hit it, you might knock the magnets off. They are glued on. | ||
| Reepicheep |
Wrestling that thing off can be pretty entertaining... those magnets are STRONG! | ||
| Tod662 |
thanks guys on to the tranny. |
