| Author | Message | ||
     Xldevil |
Trying to service my swingarm bearings and the rear isolators. The problem is how to get to the upper left nut at the swingarm mount block. How do I have to make me a wrench to loosen this nut? I know it is told how to make it at the ATC side,but I would like to have picture to get it clearer.Iīm no native speaker and I donīt think that I really understood how the wrench should look like. Or can I use a crowfoot? Second,can someone show me how the use the selfmade isolator squeezers during reinstall of the swingarm? Thanks,Ralph | ||
| Doncasto |
Ralph, The "Hoser" technique can be viewed here . . . http://www.badweatherbikers.com/cgibin/discus/show .cgi?tpc=3842&post=166020#POST166020 | ||
| Firemanjim |
Wish I had seen this earlier. I just did 2 S-1's for belt replacement and ended up using a porta power to remove just that side. Funny how I never had anything other than an S-2 so never paid attention to how to do this. |
