| Author | Message | ||
     Wickedx1 |
I have just received my PC3 and need a good baseline map. First off, do any of you have a good maps? I suppose maybe there is already on stored from the previous owner(Rockns on this site)? My mods are Force Intake, Force Race Header, Race ECM. Right now it runs way lean and bucks at around 3K at WOT. | ||
| Wickedx1 |
And more importantly, can I upload a map before installing the PC? | ||
| Mbsween |
Wicked, I don't know if you can power the PC3 from the USB port. The PCII needed 12V dc before it would "boot" Maps should be here but there aren't any for Buell. You can't use the PCII ones, I have those. You might want to check on the XB board Matt | ||
| Oldog |
Wicked I have the old force starter maps, you say that the race ecm runs lean? I presume that the 02 is in place and working.. pm me I will check and see if I still have them. | ||
| Mick |
I don't know much about EFI but theres a program developed called ECM spy which enables you to program the stock system. check out the link. http://ausbuells.informe.com/viewtopic.php?t=361 | ||
| Wickedx1 |
Yeah my Race ECU program has a lean spot on roll on below 3000rpm. Apparently the low end part of the map that came with my PC3 is close as the low end hesitation is better. But I may be leaning in the mid and high range one of my pipe slightly discolored. | ||
| Shadowracerx1 |
I have all the Buell maps from when they were available. I can email the force one (or all of them for that matter) to you. |
