| Author | Message | ||
     Sickboy |
I can't find any suitable brake levers , did I read somewhere you can use yamaha r1 levers ? Looking for some carbon look-a-likes. | ||
| Wardan123 |
Check out crg levers - they make them to fit Buells http://www.kyleusa.com/catalog/crg_brake_and_clutch_levers_2450245.htm Pretty killer huh? | ||
| Buelliedan |
kawasaki zx7 levers are the same on the brake side. | ||
| Al_lighton |
Careful, Dan. The Brake levers on the tubers and the brake levers on the XB's are very close but different. Using an XB lever on a tuber can cause a brake lockup. I'm assuming your statement applies to tubers? Is there a year that the ZX7 levers DON'T apply? Al | ||
| Lake_bueller |
The levers from a 1998 Suzuki GSXR 750 fit my Buell. I had a pair of faux carbon fiber on my bike until someone backed over it in a parking lot. The lever was on back order from Lockhart-Phillips for over 10 months. I finally gave up. | ||
| Sickboy |
Sorry about the vague question, it is a 1997 S1. And the CRG's are a bit pricey, the 98 gixxers fit? Thanks for the info. | ||
| Grndskpr |
Is there a year that the ZX7 levers DON'T apply? Not sure BUT i KNOW for a fact that 91-92 brake lever works R | ||
| Buelliedan |
Al, This is for tubers not XBs. A ZX7 brake lever works excellent on my X1 and also on my wifes Blast. | ||
| Sickboy |
What do you think on the clutch side Buelliedan ? | ||
| Another_bueller |
This is a quote from 'The X-1 files' no posting date. The adjustable brake lever from a Kawasaki ZX9R around 95-96 is a perfect match Part# 13236-1185. And the Kawasaki Zephyr had an adjustable clutch lever Part# 46076-1165. Adjustable clutch lever needs a little modification (10min switch in side) because Kawasaki switch connecter has 3 pin, Buell has 2 pin and reverse action. Brake lever is just bolt on. Total parts cost about $80 . |
